Page 1
INSTRUCTION MANUAL VCB-3372P BEDIENUNGSANLEITUNG VCB-3374P MANUEL D’INSTRUCTIONS Í [ B/W CCD Camera CCD-Schwarzweißkamera Caméra CCD Noir et Blanc C CD ½ ú T About this manual Über diese Bedienungsanleitung • Before installing and using the camera, please • Lesen Sie bitte vor der Montage und dem read this manual carefully.
Depending on the conditions of use, FEATURES installation and environment, please be sure to make the appropriate settings and • Built-in interline transfer method 1/3" adjustments. If you need help with CCD, approx. 470,000 picture elements installation and/or settings, please consult your dealer.
Disconnect or where it could be subject to direct the power cord immediately, and consult sunlight, as that could cause deformation, your dealer (or a Sanyo Authorized Service discoloration or other damages. Centre). Be careful when installing close to the...
PARTS NAMES Video output connector (VIDEO OUT: BNC type) (VCB-3372P) Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector. 12 V DC input terminal (12 V DC IN) Connect DC connecting cord from the AC adaptor to the 12 V DC IN terminal on the camera.
Page 5
Lens iris output connector (4 pin) This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens. Camera setup section (under the cover) This unit factory settings are as indicated below. These settings are for when using a 1/3 inch CS mount DC (without EE internal amplifier) type lens.
PARTS NAMES Flange-back adjustment screw (FLANGE BACK ADJ.) Flange-back lock screw (FLANGE BACK LOCK) Flange-back adjustment If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of focus (in particular when using auto-iris power zoom lenses, sold ADJ.
Page 7
Installation of a VIDEO type auto-iris lens (sold separately) 2 (A) A 1/2 or 2/3 inch C mount type lens with EE amplifier circuit that uses the video signal and a DC power source. Remove the lens mount cap. Attach the supplied C mount adaptor (A) to the auto-iris lens (B), then install the assembly on the camera.
MOUNTING THE LENS Compatible auto-iris lenses 1/3 inch Sanyo DC type lens 1/2 or 2/3 inch VIDEO type lens VCL-CS8LY: Standard angle, f= 8 mm Standard angle, f= 9 mm VCL-CS4LY: Wide angle, f= 4 mm Telephoto angle, f= 12 mm VCL-CS2LY: Ultra-wide angle, f= 2.8 mm...
CONNECTIONS Basic connection for monitoring or recording The peripheral devices (VCR, monitor, lens, etc.) and cables are sold separately. Make the video signal connection between the camera and the monitor or time lapse VCR. Turn on the power of all the devices connected to the camera.
SETTINGS [VCB-3374P] [VCB-3372P] VR401 VR401 VIDEO VIDEO A. I. A. I. E. S. LENS LENS Table A High speed electronic shutter setting 1/50 sec. Normally, the speed setting switches for the high speed ES (electronic shutter) are all set to the OFF position. This sets the electronic shutter speed to 1/50 sec.
Page 11
Electronic iris function setting Use a manual iris lens or a fixed iris lens and set the EI/BLC switch to the EI-ON position, to engage the electronic iris function. Note: Please refer to the specifications for dynamic range of the electronic iris.
SETTINGS Backlight compensation setting Use an auto-iris lens and set the EI/BLC switch to the BLC-ON position, to engage the backlight compensation function. If using a VIDEO type auto-iris lens • The ALC volume on the lens should be turned all the way to Av (Average).
TROUBLESHOOTING Before taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform correctly, please consult your dealer or a Sanyo Authorized Service Centre. No picture on the monitor screen •...
SPECIFICATIONS Camera: Scanning system : CCIR standard (625 TV lines, 25 frames/sec.) Interlace : PLL 2:1 interlace Image device : 1/3 inch solid state image device CCD Picture elements : 795 (H) x 596 (V) Effective picture elements : 752 (H) x 582 (V) Synchronizing system : Internal sync/External sync (Automatic switching): VCB-3372P Line lock/External sync (Automatic switching): VCB-3374P Resolution : 560 TV lines horizontally, 400 TV lines vertically...
Page 15
Dimensions: mm 108.5 99.5 VIDEO OUT VS IN POWER VIDEO OUT VS IN POWER SEE INSTRUCTION MANUAL 12V DC IN LINE PHASE À CLASS2WIRING 24V AC GND 24V AC 1/4”–20 UNC (VCB-3372P) (VCB-3374P) Approx. 1.8 m Approx. 1.8 m : mm Features and specifications are subject to change without prior notice or obligations.
Page 16
1AC6P1P1319-- SANYO Electric Co., Ltd. L73K2, K4/XE (1096SY) Printed in Japan...
Need help?
Do you have a question about the VCB-3372 and is the answer not in the manual?
Questions and answers