Contents 1 Important Safety Notice 2 Your clock radio Introduction What's in the box Overview of the main unit 3 Get started Activate the battery Connect power Set time and date 4 Listen to radio Tune to a radio station Adjust the volume Program radio stations automatically Program radio stations manually...
1 Important m Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: • Install the battery correctly. • Remove the battery when the unit is Safety not used for a long time. n Apparatus shall not be exposed to dripping or splashing.
negative consequences for the environment and Warning human health. • Never remove the casing of this apparatus. • Never lubricate any part of this apparatus. • Never place this apparatus on other electrical equipment. • Keep this apparatus away from direct sunlight, naked Your product contains batteries covered by flames or heat.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • enjoy the FM radio • know the time • wake up to buzz or favorite radio tone •...
Overview of the main unit a + TUNING - c AL1, AL2 • Tune to a radio station. • Enable/disable the alarm timer. • Activate the alarm time setup. b REPEAT ALARM/BRIGHTNESS CONTROL • View the alarm settings. • Repeat the alarm. • Adjust the brightness of display panel.
Page 8
/ SOURCE • Turn on or off the unit. • Switch between FM radio play, MP3 link input, and clock time display. e - VOLUME + • Adjust the volume level of radio. f Battery compartment g FM ANT • Attached FM radio antenna. h DC 5V • Power supply socket.
3 Get started To replace the battery: Always follow the instructions in this chapter in sequence. If you contact the Consumer Care, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the product.
Connect the power adapter to • the DC IN (DC 5V) jack on the back of the main unit, and • the power socket. Set time and date In clock mode, press and hold SET TIME/ PROG for 2 seconds. Press PRESET +/PRESET -.
4 Listen to radio Program radio stations manually Note Tune to a radio station • You can program a maximum of 20 preset radio stations. Press SOURCE repeatedly to turn on the Press SOURCE repeatedly to turn on the radio. radio.
5 Set the alarm View the alarm settings timer Press AL1/AL2. Repeat alarm Set the alarm time When the alarm rings, press REPEAT ALARM/BRIGHTNESS CONTROL. You can set two alarms. » The alarm repeats ringing 9 minutes later. Note • Before you start, ensure that the clock time is set Stop alarm ring correctly.
6 Other features Set the sleep timer You can set the radio to turn off automatically after a certain period of time. Press SLEEP repeatedly to select a preset period of time. appears. » » The volume decreases gradually in the last 5 minutes.
> 28 dBf Total Harmonic Distortion < 3% Signal to Noise Ratio > 50 dB General information AC Power Model: TPA107-50050-EU (F) (Philips) Input: 100-240 V ~, 50/60 Hz, 0.5 A Output: 5.0 V 1.0 A Operation Power 4.0 W Consumption...
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available.
Need help?
Do you have a question about the AJ1003 and is the answer not in the manual?
Questions and answers