Contents 1 Important 6 Replacing the filter Safety Understanding the healthy air protect lock Replacing the filters 2 Your air purifier Filter type change Product overview (fig.a) Controls overview (fig.b) 7 Troubleshooting 3 Getting started 8 Guarantee and service Installing filters Order parts or accessories Wi-Fi setup 9 Notices...
Important If the power cord is • damaged, you must have it replaced by Philips, a service center authorized Safety by Philips, or similarly qualified persons in order Read this user manual carefully before you use the appliance, and save it for to avoid a hazard.
Page 5
If the power socket used • Only use the original • to power the appliance Philips filters specially has poor connections, intended for this the plug of the appliance appliance. Do not use any becomes hot. Make other filters.
Page 6
Always lift or move the To prevent interference, • • appliance by the handle place the appliance at on top of the appliance. least 2 meters away from Do not insert your fingers electrical appliances that • or objects into the air use airborne radio waves outlet or the air inlet to such as TVs, radios, and...
3 Getting started Congratulations on your purchase, and welcome to Philips! Installing filters To fully benefit from the support that Philips offers, register your product at Note www.philips.com/welcome. • Make sure the air purifier is unplugged from the electrical outlet before Product overview (fig.a)
• This app supports the latest versions of orange for the first time. Android and iOS. Please check Make sure that your mobile device www.philips.com/purifier-compatibility is successfully connected to your for the latest update of supported Wi-Fi network. operating systems and devices.
4 Using the Note appliance • After the appliance is switched off by the on/off button , if the plug is still in the power socket, the appliance will operate under the previous settings when it is switched on again. Understanding the air quality light Changing the Auto mode...
Bacteria/Virus mode Setting the timer The specially designed Bacteria & Virus With the timer, you can let the mode can effectively remove bacteria appliance operate for a set number of & viruses such as staphylococcus albus hours. When the set time has elapsed, and H1N1.
5 Cleaning Using the light on/off function With the light on/off button, you can Note switch on or off the air quality light, • Always unplug the appliance before the display screen and the function cleaning. indicators if needed. • Never immerse the appliance in water Touch the light on/off button or any other liquid.
Cleaning the air quality Cleaning the pre-filter sensor Clean the pre-filter when F0 is displayed on the screen(fig.{). Clean the air quality sensor every Pull the bottom part of the front 2 months for optimal functioning of the panel to remove it from the purifier.
• Do not clean the filters with a vacuum cleaner. • If the pre-filter is damaged, worn or broken, do not use. Visit www.philips.com/support or contact the Consumer Care Center in your country.
Filter type change Touch for 3 seconds to enter the filter type change mode (fig.€). » Code (A3) of the NanoProtect filter Series 3 displays on the screen. Touch to select the filter code of the new filter you will use (fig.). Touch and hold for 3 seconds to confirm the filter code of the new...
7 Troubleshooting This chapter summarizes the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, contact the Consumer Care Center in your country. Problem Possible solution • Check if the front cover is properly installed. The appliance •...
Page 16
Problem Possible solution • The filter may produce smell after being used for a while because of the absorption of indoor gases. It’s recommended that you reactivate the filter by putting it in The appliance direct sunlight for repeated use. If odor still exists, replace produces a strange the filter.
Page 17
Problem Possible solution • If the router your purifier is connected to is dual – band and currently it is not connecting to a 2.4GHz network, please switch to another band of the same router (2.4GHz) and try to pair your purifier again. 5GHz networks are not supported.
(you find its phone number regarding exposure to electromagnetic in the worldwide guarantee leaflet). If fields. there is no Consumer Care Centre in your country, go to your local Philips dealer. Compliance with EMF Koninklijke Philips N.V. manufactures Order parts or...
Software App Store is a service mark of Apple Inc. Google Play is a trademark of Google Inc. This Philips appliance and Air Matters app applied multiple open source softwares, copies of open source software license text used in this product can be derived from website: www.philips.com/purifier-compatibility.
Need help?
Do you have a question about the AC3259 and is the answer not in the manual?
Questions and answers