Related Manuals for NEC Topaz
Summary of Contents for NEC Topaz
- Page 1 LATOP-009 Hybrid Telephone System Paging / Doorphone Interface Card (2PGDU) Guide Issue : 1.0 Date : April, 2005...
- Page 2 No representation is made that this manual is complete or accurate in all respects and NEC Unified Solutions, Inc. shall not be liable for any errors or omissions. In no event shall NEC Unified Solutions, Inc. be liable for any incidental or consequential damages in connection with the use of this manual.
-
Page 3: Table Of Contents
Assign the System’s Music on Hold .........................17 Assign the Music on Hold to a Trunk .......................18 Assign the Music on Hold to an ISDN DDI Number..................19 Topaz Configuration Mode ..........................22 User Guide................................24 Door Phone & Door Lock Release ........................24 External Page ..............................25... -
Page 4: What Is The 2Pgdu Card
2 Relay contacts. These can be assigned to any of the door phones or audio ports of the 2PGDU card. Both relay contacts are connected via a single RJ11 plug. You can install one 2PGDU card into each of the Topaz main or expansion units giving a total of three cards. Audio ports... -
Page 5: System Connection Diagram
System Connection Diagram System Connection Diagram External Paging Topaz System External Music Source Door Phone Unit and Door Lock Each Topaz unit can have a 2PGDU card installed. Topaz 2PGDU Guide... -
Page 6: Installation Procedure
Installation Procedure Installation Procedure Unpack the 2PGDU Power off the Topaz and install the 2PGDU card Power on the Topaz Configure the 2PGDU ports Connect the external device(s) 1- Required Items. The 2PGDU card is required with: Additional Items •... -
Page 7: 2- Install The 2Pgdu Card
• Wear a suitable anti-static strap connected to an Earth point. The 2PGDU card is installed onto the base board within the Topaz main or expansion units. One 2PGDU card can be installed into each main/expansion unit. ! When installing the 2PGDU card the installation order below shows the port assignment:... - Page 8 ON. This will ensure that the system memory retains your configuration. The NORMAL switch is located to the right of the ST connector on the main unit, refer to the Getting Started Guide supplied with the Topaz for further information. Topaz 2PGDU Guide...
-
Page 9: 3- Door Phones And Door Locks
(There is also an option to connected a door lock device to the Topaz, you can then release the door lock and allow the visitor to enter, refer to the Door Lock section within this guide). -
Page 10: Configure The Ring Assignment For The Door Phone Units
Configure the Ring Assignment for the Door Phone Units Each door unit will alert (ring) at a group of telephones when the button is pressed on the door unit. The Topaz can have up to six door units installed. Program 10-03-01 Each 2PGDU card can have 2 door phones. - Page 11 Press HOLD to confirm the entry and step to the next member number. When you are finished: Press DC several times when you are done to return to the Program Mode. (Press SPK to save changes and exit if you are finished). Topaz 2PGDU Guide...
-
Page 12: Connect The Door Lock Unit
Door Phones and Door Locks Connect the Door Lock Unit You can connect an external door lock that can be controlled by the Topaz 2PGDU card. • The 2PGDU card provides two pairs of normally open relay contacts. The contacts are closed when the door lock is released. - Page 13 These settings are from Program 32-02-01 for each door phone enter the telephone numbers that each door phone will ring for each night mode. ! You can also identify the location (e.g. Front Door) and if a door lock is installed on this sheet. Telephone Ring Assignment for each Night Mode Door Phone Topaz 2PGDU Guide...
-
Page 14: 4- External Paging
External Paging 4- External Paging You can connect the audio ports of the Topaz to an external Public Address (PA) system. Any telephone can then place an external paging call over the PA system. Each 2PGDU card has two audio ports, you can install one 2PGDU card into each Topaz main/expansion unit giving a total of six audio ports. - Page 15 Default: Audio Port number Page Zone Confirm the 2PGDU audio port number number to page zone number assignment. The Topaz can have up to 6 external paging zones. Record the settings on this sheet. Audio port 31-04-01 SPK 1 number (1-6)
-
Page 16: 5- External Music On Hold
External Music 5- External Music on Hold You can connect the audio ports of the Topaz to an external music device. The external music can be played to calls placed in hold. Each 2PGDU card has two audio ports, you can install one 2PGDU card into each Topaz main/expansion unit giving a total of six audio ports. -
Page 17: Connect The External Music System
Program 10-03-01 The Topaz can have a 2PGDU card installed into each Topaz main/expansion unit. Set the audio port of the Each 2PGDU card has 2 audio ports which can be configured for 2PGDU card to External Music either external music or external paging. -
Page 18: Assign The System's Music On Hold
External Music Assign the System’s Music on Hold The system’s music on hold can be either a tune generated by the system or an external music device connected to the MOH socket of the Topaz main unit. Program 10-04-01 Default: The Topaz generated tune is used. -
Page 19: Assign The Music On Hold To A Trunk
601 When you are finished: for ACI port 1 etc. Press DC several times when you are done to return to the Program Mode. (Press SPK to save changes and exit if you are finished). Topaz 2PGDU Guide... -
Page 20: Assign The Music On Hold To An Isdn Ddi Number
601 When you are finished: for ACI port 1 etc. Press DC several times when you are done to return to the Program Mode. (Press SPK to save changes and exit if you are finished). Topaz 2PGDU Guide... - Page 21 Configuration Sheet: Music On Hold Type The default music source for each trunk and DDI is the system music tune set by Program 10-04-01. At default the system music tune is the Topaz generated tune. Music per Trunk Music per DDI...
- Page 22 Any spare extension number e.g. 601 1=Input ! Note. You can test the ACI port by placing a call to its ACI extension number, you can then listen to the external music device to confirm you configuration is correct. Topaz 2PGDU Guide...
-
Page 23: Topaz Configuration Mode
Press HOLD You will see - Program Mode Selecting the Program Number • Each configuration setting within the Topaz is identified by a Program Number (eg 22-05-01). Ensure the LCD display shows: Program Mode If it is not displayed press the DC key several times. - Page 24 • With the Program Number entered and the curser positioned at the first entry you can change the value by entering the new one with the numeric keys of the Topaz phone. • When you have entered the new value press HOLD to confirm it and move to the next entry.
-
Page 25: User Guide
You must have answered the door phone call first before you Example: can release the door lock. You will hear a confirmation FLASH Press FLASH 16:28PM beep. UNLOCKED DOOR The door lock will be released for 10 seconds. Topaz 2PGDU Guide... -
Page 26: External Page
Dial the External Page Zone 16:28PM comfirmation tune. number 1-6 PAGE EXT GRP 03 Wait for the external paging tune to end. Speak into your handset, your speech will be broadcast to the external loudspeakers. Go on hook to end. Topaz 2PGDU Guide...
Need help?
Do you have a question about the Topaz and is the answer not in the manual?
Questions and answers