Philips mcm2005 micro music system user manual (17 pages)
Summary of Contents for Philips MCM761/12
Page 1
Register your product and get support at www.philips.com/welcome EN User manual DA Brugervejledning DE Benutzerhandbuch ES Manual del usuario FR Mode d’emploi Manuale utente NL Gebruiksaanwijzing SV Användarhandbok MCM761...
Contents 1 Important Safety Notice 2 Your Micro Hi-Fi System Introduction What’s in the box Overview of the main unit Overview of the remote control 3 Get started Connect FM antenna Connect MW antenna Connect speakers Connect power Prepare the remote control Auto install radio stations Set clock Turn on...
1 Important Safety a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
This product complies with the requirements of the following directives and guidelines: 2004/108/EC + 2006/95/EC device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. The making of unauthorized copies of...
2 Your Micro Hi- Fi System Congratulations on your purchase, and support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can enjoy audio from discs, tapes, USB devices, external devices, or radio stations. When you play a tape, you can freely change a tape side without a need to manually re-load the tape.
Overview of the main unit a STANDBY-ON/ECO POWER Turn on the unit, or switch to standby mode, or switch to Eco Power Standby. b Disc compartment door c iR Remote sensor. d Display panel Show current status.
Jack for a USB mass storage device. f PLAY/PAUSE Start or pause disc/USB play. Start tape play. g PRESET / Skip to the previous/next track. Select a preset radio station. Change a tape side. h ALBUM/TUNING / Skip to the previous/next album. Search within a track/ disc/USB/tape.
Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. Write the numbers here: Model No.
Connect MW antenna Assemble the MW loop antenna. Connect the MW loop antenna to the MW jack on the back of the main unit. Connect speakers Caution For optimal sound, use the supplied speakers only. Connect only speakers with impedance that is the same or higher than the supplied speakers.
Prepare the remote control Caution Risk of explosion! Keep batteries away from heat, To replace the remote control battery: Open the battery compartment. Insert 2 AA batteries with correct polarity (+/-) as indicated. Close the battery compartment. Note If you are not going to use the remote control for a long time, remove the batteries.
To select an album, press ALBUM To search within a track, press and hold ALBUM then release to resume normal play. Play USB Note Ensure that the USB device contains playable audio contents for supported formats. (see ‘USB playability information’ on page 17) Plug the USB device into the this unit.
all) is displayed: all tracks are played continuously in a random play. To return to normal play, press REPEAT and SHUFFLE. Program tracks You can program a maximum of 40 tracks. At CD/USB mode, in the stop position, press PROGRAM to activate the program mode.
8 USB record recorded in .wma format. called ‘PHILIPS’ is automatically created in the USB device. Each time you record to USB, the ‘PHILIPS’ folder. Files and sub-folders are named numerically in the order in which they are created.
Note If the USB device does not have enough memory to store the CD track, a message about a full memory is displayed. 9 Record to tape Note To record, use only “Normal” (IEC type I) tapes on which the write-protect notches (tabs) are not broken.
Listen to an external device You can listen to an external audio device through this unit. Press AUX to select the AUX source. Connect the audio cables (white/red jacks, not supplied) to: the AUX IN jacks on the back of the unit.
Speakers Speaker Impedance 4ohm Woofer 1 x 5.25” Tweeter Ribbon tweeter Dimensions 175 x 252 x 196mm (W x H x D) Weight 2.97kg each General information AC power 220 - 240V, 50Hz Operation power consumption Standby power <15W consumption Eco power standby <1W consumption...
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site www. philips.com/welcome. When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Need help?
Do you have a question about the MCM761/12 and is the answer not in the manual?
Questions and answers