Quick Start Guide
What's in the Box?
You should find these items upon opening the box.
Stand
FM wire antenna
MW antenna
1 dock & 8 Dock
Power adaptor
User manual
Adapters for iPod
MCM239D
Install
Mounting the stand onto the set
1
Locate the bottom of the main unit and find the slot, then slide the stand
in the slot until it stops, as indicated in the figure.
Rear connections
Step A
Install
Speaker
(right)
Step
B
Prepare
Step
C
Enjoy
CR2025
Remote control with
1 x CR2025 battery
1
Connect the cable of the left speaker to LEFT (red and black) and the cable
of the right speaker to RIGHT (red and black).
2
Extend the wire antenna and fit it to FM ANTENNA.
3
Quick start guide
Insert the MW antenna to MW ANTENNA jacks.
4
Connect the AC power cord to the wall socket.
MW loop
antenna
Speaker
(left)
FM wire
antenna
Power adaptor
Tip
– To receive optimal radio reception, put the
main unit and the antennas as far away as
possible from the power adaptor.
Setup
Setup
Setting the clock
1
Press and hold STANDBY-ON/ ECO POWER y to switch the set to Standby mode.
➜ The display shows the set time.
➜ -- --:-- -- flashes by default if you have not set the clock.
2
In the standby mode, press and hold DISPLAY/CLOCK on the remote control.
➜ 24 HR or 12 HR appears for the initial clock setting. To select 12-hour clock or
24-hour clock,
1. Press VOLUME +/- once or more.
2. Press DISPLAY/CLOCK to confirm.
➜ The hours digits start flashing.
3
Hold down or press VOLUME +/- repeatedly to set the hours.
4
Press DISPLAY/CLOCK to confirm.
5
Hold down or press VOLUME +/- repeatedly to set the minutes.
6
Press DISPLAY/CLOCK to confirm.
Helpful hints:
- To set the clock automatically by using a time signal which is broadcast
together with the RDS signal, see the User Manual, RDS: Setting the RDS clock.
Enjoy
Playing discs
With this system, you can play all pre-recorded audio CDs (CDDA), all finalized audio CD-Rs
and CD-RWs, MP3/WMA-CDs (CD-Rs/CD-RWs with MP3/WMA files)
1
Press SOURCE once or more to select CD (or CD on the remote control).
2
Press DOOR OPEN to open the CD compartment.
3
Insert a disc with the printed side facing up. Then close the CD door.
4
Press ÉÅ to start playback.
5
To stop playback, press STOPÇ.
IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control
Notes for remote control:
– First, select the source you wish to
control by pressing one of the source
select keys on the remote control (CD or
TUNER, for example).
– Then select the desired function
( 2;, 4 , ¢ for example).
Need help?
Do you have a question about the MCM239D/12 and is the answer not in the manual?
Questions and answers