Page 2
País de Origen: China Nº de Serie: LEA CUIDADOSAMENTE ESTE INSTRUCTIVO AVISO IMPORTANTE Philips Mexicana, S.A. de C.V. no se hace responsable por daños o desperfectos causados por: – Maltrato, descuido o mal uso, presencia de insectos o roedores (cucarachas, ratones etc.).
Page 5
Index English ------------------------------------------------ 6 Français -------------------------------------------- 18 Español --------------------------------------------- 32 -------------------------------------------------------- 45...
Contents General Information Environmental information ... 7 Supplied accessories ... 7 Safety information ... 7 Preparations Rear connections ... 8–9 Optional connection ... 9 Before using the remote control ... 9 Replacing battery (lithium CR2025) into the remote control ... 9 Controls Controls on the system and remote control ...
IMPORTANT! PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V-127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM. Environmental Information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene...
Preparations MW loop antenna Speakers (right) AC power cord Rear connections The type plate is located at the rear of the system. Power Before connecting the AC power cord to the wall outlet, ensure that all other connections have been made. –...
FM Antenna ● For better FM stereo reception, connect an outdoor FM antenna to the FM AERIAL (FM ANTENNA) terminal. Speakers Connection Front Speakers Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", coloured (marked) wire to "+"...
Controls (illustrations on page 3) Controls on the system and remote control STANDBY-ON – switches the system on or to standby. Display – shows the status of the system. OPEN • CLOSEç – opens/ closes the CD door. – remote sensor VOLUME (3 / 4 ) (+/-) –...
IMPORTANT! Before you operate the system, complete the preparation procedures. Switching the system on ● Press STANDBY-ON / 2. ➜ The system will switch to the last selected source. ● Press SOURCE (or CD, TUNER or AUX on the remote control). ➜...
CD Operation IMPORTANT! The lens of the CD player should never be touched. Playing a disc This CD player plays Audio Discs including CD- Recordables and CD-Rewritables. ● CD-ROM, CD-I, CDV, VCD, MP3, DVD or computer CDs, however, are not possible. Press SOURCE to select CD.
Different play modes: SHUFFLE and REPEAT You can select and change the various play modes before or during playback. The play modes can also be combined with PROGRAMME. SHUFFLE ... tracks of the entire disc/ programme are played in random order SHUFFLE and REPEAT ALL…to repeat the entire disc/ programme continuously in random order...
Radio Reception Tuning to radio stations Press SOURCE to select TUNER. ➜ TUNER is displayed briefly. Press BAND (or TUNER on the remote control) once or more to select your waveband. (FM/ MW) Press and hold TUNE à or á. ➜...
Setting the clock In standby mode or system on, press and hold CLOCK SET on the remote control for more than 3 seconds. ➜ SET CLOCK scrolls on the display. ➜ The clock digits for the hours flash. Press VOLUME +/- to set the hours. Press CLOCK SET again.
Cleaning the disc lens ● After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good playback quality, clean the disc lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with...
Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.
Need help?
Do you have a question about the MC230/15 and is the answer not in the manual?
Questions and answers