Advertisement
Quick Links
Backup Alarm Kit
Model No. 31512
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
The Backup Alarm Kit can be installed on the following
machines:
•
Groundsmaster 4000 Series
•
Groundsmaster 4100 Series
•
Groundsmaster 5900 Series
Note:
This kit is not for use on the Outcross 9060.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
Backup alarm
Hex-head screw (1/4 x 3/4 inch)
Flange nut (1/4 inch)
Wire harness
Tie clip
Clamp
Cable tie
No parts required
No parts required
Register at www.Toro.com.
Qty.
–
Prepare the machine.
1
2
2
1
Install the backup alarm.
2
1
2
–
Enable the alarm in the InfoCenter.
–
Check the backup alarm.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Lower the cutting units.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Disconnect the negative battery cable from the
battery.
6.
Disconnect the positive battery cable from the
battery.
Original Instructions (EN)
All Rights Reserved *3435-312* A
Printed in the USA
Form No. 3435-312 Rev A
Installation Instructions
Use
Advertisement
Summary of Contents for Toro 31512
- Page 1 Form No. 3435-312 Rev A Backup Alarm Kit Model No. 31512 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Backup alarm...
- Page 2 Installing the Backup Alarm Parts needed for this procedure: Backup alarm Hex-head screw (1/4 x 3/4 inch) Flange nut (1/4 inch) g032353 Wire harness Figure 2 Tie clip 1. Wire harness 3. Rear frame Clamp 2. Tie clips Cable tie Insert the wire harness into the clamp (Figure Installing the Backup Alarm...
- Page 3 Installing the Backup Alarm Secure the clamp and wire harness to the rear frame with the bolt and washer removed in the Groundsmaster 5900 Series Machines previous step (Figure Coil the harness and secure it with a cable tie (Figure Install the backup alarm as shown in Figure g032356...
- Page 4 Checking the Backup Alarm No Parts Required Procedure Perform the following steps to ensure that the backup alarm is working: g020650 Turn the key in the switch to the O position. Figure 8 Note: Do not start the engine. 1. Indicator light 3.
Need help?
Do you have a question about the 31512 and is the answer not in the manual?
Questions and answers