Advertisement
Quick Links
Crosscut Position Kit
For Groundsmaster 4500-D
Model No. 30832
Installation
1. Position the machine on a level surface, lower the
cutting decks to the floor, shut the engine off and
engage the parking brake.
2. Remove the (4) 5/16 inch x 5/8 inch flange bolts
securing the floor plate to the frame (Figure 1).
Remove the floor plate.
Figure 1
1. Floor plate
3. Using the dimensions shown in Figure 2, locate,
mark and drill a 13/16 inch diameter hole through
the floor plate and foot tread.
Figure 2
1. 4–1/2 inches
2. 15–7/8 inches
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
3. 13/16 inch diameter hole
Register at www.Toro.com.
4. Remove the front center deck from the traction unit
as follows:
A. Disconnect and remove the hydraulic motor
from the deck. Cover the top of the deck spindle
to protect it from contamination.
B. Remove the lynch pin securing the deck carrier
frame to the lift arm pivot pin.
C. Roll the cutting deck away from the traction unit.
5. Using the dimensions shown in Figure 3, locate,
mark and drill (2) 7/32 inch diameter holes in the
top of the front frame tube.
1. 4–53/64 inches
2. 7/16 inch
6. Mount the spring bracket to the top of the frame
tube with (2) ¼ inch self tapping flange bolts
(Figure 4).
1. Spring bracket
Form No. 3329-829 Rev B
Installation Instructions
Figure 3
3. 1–3/8 inches
4. 7/32 inch diameter
Figure 4
2. Self tapping bolt
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 30832
Summary of Contents for Toro 30832
- Page 1 Form No. 3329-829 Rev B Crosscut Position Kit For Groundsmaster 4500-D Model No. 30832 Installation Instructions Installation 4. Remove the front center deck from the traction unit as follows: 1. Position the machine on a level surface, lower the cutting decks to the floor, shut the engine off and A.
- Page 2 7. Reposition the fittings on the #4 and #5 cutting deck lift cylinders so the hoses are routed toward the middle of the machine (Figure 5). Cable tie the hoses together to prevent any interference (2 ties each). Figure 5 1.
- Page 3 14. Position the longer end of the turnaround shaft 17. Place the floor plate w/bushing over the turnaround between the cylinder stop brackets until the shaft shaft and into mounting position (Figure 10). Secure bracket holes align with the cylinder stop bracket the floor plate to the frame with the (4) flange bolts hole (Figure 8).
- Page 4 22. While compressing the spring, insert the hair pin cotter into the second hole from the bottom of the shaft (Figure 12). To change the spring tension, move the hair pin cotter to another position on the shaft. Figure 12 1.
Need help?
Do you have a question about the 30832 and is the answer not in the manual?
Questions and answers