Table of Contents
Related Manuals for Beko TLDA628
Summary of Contents for Beko TLDA628
- Page 1 BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko.co.uk website: www.beko.co.uk Printed in Turkey Part no: 48 3186 00 00 Revision no: 0 13.0 cu.ft. Tall Larder Fridge TLDA 628...
-
Page 2: Table Of Contents
• This fridge must only be used for its intended purpose i.e. the storing of edible foodstuff. • Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is an ongoing commitment. This appliance which is among the latest range introduced is particularly environment friendly. -
Page 3: Safety First / Electrical Requirements
22mm. Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed. CORD GRIP packing as supplied must be intact during transportation. -
Page 4: Installation Instructions
IMPORTANT INSTALLATION INSTRUCTIONS 1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres. 2. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances: From Cookers... -
Page 5: Chiller Zone Compartment Drawer
The following guidelines and recommendations are suggested to obtain the best results and storage hygiene. 1. The larder fridge is suitable for the short term storage of fresh food and drinks. 2. Cooked dishes must be stored in airtight covered containers. 3. -
Page 6: Starting
STARTING Final Check Before you start using the refrigerator check that: 1. The front feet have been adjusted so the appliance is level. 2. The interior is dry and air can circulate freely. 3. Clean the interior as recommended under "CLEANING AND CARE." 4. -
Page 7: Replacing The Interior Light Bulb
REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work switch off at the socket outlet and pull out the mains plug. Use a cross headed screw driver to remove the light diffuser cover. Then ensure the bulb is screwed in until it is secure in the bulb holder. Replace the plug and switch on. -
Page 8: Reversing The Door
REVERSING THE DOOR We recommend that you reverse the door before switching on for the first time. Tools required: Small and medium size flat and cross-headed screwdrivers, a pair of pliers. Spare Parts supplied in the plastic bag: The following parts, which are exclusively for left hand side fitted hinge operation are supplied in a plastic bag with the appliance: - Door top trim hinge covers –... -
Page 9: Guarantee Details
• The cost of functional replacement parts, but excluding consumable items. • The labour costs of a Beko approved repairer to carry out the repair. What is not covered? • Transit, delivery or accidental damage or misuse and abuse.
Need help?
Do you have a question about the TLDA628 and is the answer not in the manual?
Questions and answers