Makita DTW450 Installation Instructions Manual
Hide thumbs
Also See for DTW450:
- Instruction manual (56 pages) ,
- Instruction manual (12 pages) ,
- Instruction manual (53 pages)
Related Manuals for Makita DTW450
Summary of Contents for Makita DTW450
- Page 1 INSTRUCTION MANUAL Cordless Impact Wrench DTW450 008145 IMPORTANT: Read Before Using.
-
Page 2: Specifications
EC Declaration of Conformity Noise Makita Corporation responsible The typical A-weighted noise level determined according manufacturer declare that the following Makita to EN60745: machine(s): Sound pressure level (L ) : 94 dB (A) Designation of Machine: Sound power level (L... -
Page 3: General Power Tool Safety Warnings
Do not abuse the cord. Never use the cord for representative in Europe who is: carrying, pulling or unplugging the power tool. Makita International Europe Ltd, Keep cord away from heat, oil, sharp edges or Michigan, Drive, Tongwell, moving parts. Damaged or entangled cords Milton Keynes, MK15 8JD, England increase the risk of electric shock. - Page 4 18. Do not use the power tool if the switch does 29. Follow instruction lubricating not turn it on and off. Any power tool that cannot changing accessories. be controlled with the switch is dangerous and 30. Keep handles dry, clean and free from oil and must be repaired.
-
Page 5: Functional Description
Do not short the battery cartridge: FUNCTIONAL DESCRIPTION Do not touch the terminals with any conductive material. CAUTION: Avoid storing battery cartridge in a Always be sure that the tool is switched off and the • container with other metal objects such as battery cartridge is removed before adjusting or nails, coins, etc. - Page 6 tool stops may damage the tool. Installing or removing socket The switch is reversible, providing either clockwise or 1. Socket counterclockwise rotation. To start the tool, simply pull 2. Anvil the lower part (A) of the switch trigger for clockwise or the upper part (B) for counterclockwise.
-
Page 7: Operation
The hook is convenient for temporarily hanging the tool. Standrad bolt This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool (kgf cm) housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. -
Page 8: Maintenance
Only use accessory or reduction in the fastening torque. attachment for its stated purpose. If you need any assistance for more details regarding MAINTENANCE these accessories, ask your local Makita Service Center. Sockets • Extension bar • CAUTION: Universal joint •... - Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 885280-223...
Need help?
Do you have a question about the DTW450 and is the answer not in the manual?
Questions and answers