CO NT R O L PA N E LS C P 6 0 0 - P R O Contents Introduction ............................. 4 Safety guide ............................5 1 Before you start ......................... 6 2 Hardware connection ........................ 6 3 Basic settings ..........................6 Set IP address ..........................
Introduction The quick start guide describes the steps to download Panel Builder project to CP600-Pro de- vices. The document refers to the following models: CP6605 Control Panel, TFT graphical display, multi-touchscreen, 5”, 800 x 480 pixel CP6607 Control Panel, TFT graphical display, multi-touchscreen, 7”, 800 x 480 pixel CP6610 Control Panel, TFT graphical display, multi-touchscreen, 10.1”, 1280 x 800 pixel...
CO NT R O L PA N E LS C P 6 0 0 - P R O Safety guide The manual contains safety standards that must be respected for the personal safety and to avoid damage. Indications of attention are divided into three levels of severity: DANGER: indicates a failure to observe safety rules and such failure may cause death or seri- ous injuries.
24 V DC power supply Ethernet cable Basic settings Click on System Settings when CP600-Pro HMI is powered on for the first time. Set IP address Click on Network tap and then click on EDIT to set the IP address.
NOTE: Please make sure you have the right license Download your first project Demo projects are prepared to help you get familiar with Panel Builder and CP600-Pro fea- tures. Please find the demo projects of your CP600-Pro HMI via below link:...
Page 7
Click Download, and then PB610 Panel Builder 600 will switch the CP600-Pro to Configuration Mode and transfer the files. NOTE: If the Runtime is not installed to CP600-Pro, PB610 Panel Builder 600 will promote to Install Runtime 3AD R 0 10 16 1 , 1 , en _U S...
Need help?
Do you have a question about the CP600-Pro and is the answer not in the manual?
Questions and answers