Advertisement
Table of Contents
LED Lamp Kit
Greensmaster
Model No. 132-6960
Note: This kit replaces standard lights with LED lights. A light kit must already be installed on the machine.
This product contains a chemical or chemicals known to the State of California to
Installing the Kit
1. Park the machine on a level surface, turn off the engine,
and remove the key.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or bystanders.
Remove the key from the ignition switch
before you do any maintenance.
2. Disconnect the negative ( - ) battery cable from the
battery.
3. Disconnect the existing lamp from the wiring harness.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3000 Series Traction Unit with Light Kit
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
4. Remove the existing carriage bolt, nut, and lamp from
the support bracket
(Figure
Figure 1
1. Lamp
2. Carriage bolt
Original Instructions (EN)
All Rights Reserved *3396-562* A
Printed in the USA
Form No. 3396-562 Rev A
Installation Instructions
1).
3. Support bracket
4. Nut
Advertisement
Table of Contents
Related Manuals for Toro 132-6960
Summary of Contents for Toro 132-6960
- Page 1 Form No. 3396-562 Rev A LED Lamp Kit Greensmaster ® 3000 Series Traction Unit with Light Kit Model No. 132-6960 Installation Instructions Note: This kit replaces standard lights with LED lights. A light kit must already be installed on the machine. WARNING CALIFORNIA...
- Page 2 5. Install the LED lamp to the support bracket using a 6. Connect the kit wiring harness to the LED lamp carriage bolt, lockwasher, and nut (Figure (Figure Figure 3 1. Kit wiring harness 2. Existing wiring harness Figure 2 7.
Need help?
Do you have a question about the 132-6960 and is the answer not in the manual?
Questions and answers