Page 4
Each cup is freshly brewed, so you're always sure of a pure and round taste. SENSEO\ combines a unique brewing method from Philips with convenient coffee pods from Douwe Egberts, available in different blends of fine roast and ground coffee.Together they make sure you only get the very best in flavour...
◗ If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.
Page 6
ENGLISH Fill the water reservoir with cold water up to the MAX indication and put it back into the machine. Release the lid by moving the lever upwards. Open the lid. Put the 1-cup or 2-cup pod holder in the machine without pod(s).
◗ The machine will fill itself with water from the water reservoir. Now your Philips SENSEO\ coffee machine is ready for use. Brewing coffee Never pour milk, coffee, hot water or carbonated water into the water reservoir. - ° MIN: minimum amount of water required to brew 1 cup of - °°...
Page 8
ENGLISH Release the lid by moving the lever upwards. Open the lid. First place the appropriate pod holder in the machine. Make sure the pod holder is clean and the sieve in the centre is not clogged, e.g. loose coffee grounds. ◗...
Page 9
Close the lid and lock the lever. Always check if the lid is properly locked.The lever must be pushed down until it snaps home with a click. Never start brewing with the lid open.The lid must be properly closed. Place one cup or two cups under the outflow openings. The cups you use should have a capacity of at least 150 ml.
ENGLISH ◗ If you intend to make another cup of SENSEO\ coffee later, just leave the coffee machine switched on.The machine will automatically switch itself off after 1 hour. Cleaning Never immerse the SENSEO\ coffee machine in water. Never clean the machine by flushing it with the lid open. Always unplug the machine before cleaning it.
Clean the pod holders in hot water, if necessary with some washing-up liquid, or in the dishwasher. Check if the sieve in the centre of the pod holder is clogged. If this is the case, unclog the sieve by rinsing the pod holder under a running tap.
ENGLISH Put a bowl (with a capacity of at least 1500 ml) under the coffee outflow openings to collect the water. Press on/off button I and subsequently press buttons ° and °° briefly at the same time. The machine will fill itself with water from the water reservoir.This will take some time and you will probably not notice that this is happening.
Page 13
Replacement All removable parts can be orderd from your Philips dealer or a Philips service centre. Environment ◗ Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for recycling.
Page 14
The purchase of the Philips SENSEO coffee machine does not exhaust any of the rights of Sara Lee/Douwe Egberts or Philips under any of their patents nor does it confer upon the purchaser a licence under these patents.
(this water would normally end up in the water reservoir). In all other cases, contact the Philips Customer Care Centre in your country. A vacuum may have temporarily formed under the lid.
Page 16
If it is, unclog the sieve by holding the pod holder under a running tap. If necessary, you can use a washing-up brush or a pin to unclog the sieve. If problems continue to occur, contact the Philips Customer Care Centre in your country.
Need help?
Do you have a question about the Senseo HD7810 and is the answer not in the manual?
Questions and answers