Advertisement
Quick Links
Advertisement
Summary of Contents for AEG MMS18SBL
- Page 1 MMS18SBL Original instructions...
- Page 2 Important! It is essential that you read the instructions in this manual before assembling, operating and maintaining the product. Subject to technical modifications.
- Page 3 1. Filter 10. Hex key 2. Handle, insulated gripping surface 11. Cutting depth adjustment screw 3. Variable speed switch trigger 12. 3/8” (9.5 mm) inner flange 4. Blade direction selector 13. 7/16” (11 mm) inner flange 5. Wheel guard 14. Abrasive cut-off wheel 6.
- Page 5 START STOP...
- Page 6 Remove the battery pack before starting any work on the machine. click...
- Page 7 75-100 % 50-75 % 25-50 % 0-25 %...
- Page 9 Adjust cutting depth thickness of the workpiece.
- Page 11 ø 9.5 mm ø 11 mm Flange screw size: M6...
- Page 12 click...click...click... click...click...click...
- Page 14 START STOP...
- Page 15 15 sec...
- Page 17 Adjust the cutting depth to the thickness of the workpiece.
-
Page 18: Technical Data
L1890R L1820S tools. Wheels intended for a larger power tool are not suitable for Use AEG 18V battery and charger only the higher speed of a smaller tool and may burst. WARNING! Read all safety warnings, instructions, tool. Failure to follow all instructions listed below may result in that do not match the mounting hardware of the power tool will run out of balance, vibrate excessively and may cause loss of control. -
Page 19: Kickback And Related Warnings
AEG Distributors offer to retrieve old batteries to protect our environment. For example, if an abrasive wheel is snagged or pinched by the... -
Page 20: Risk Reduction
whenever possible. Temperatures in excess of 50°C (122°F) reduce the performance of the battery pack. Avoid extended exposure to heat or sunshine Injury caused by vibration (risk of overheating). – Limit exposure. See Risk Reduction. The contacts of chargers and battery packs must be kept clean. RISK REDUCTION For an optimum life-time, the battery packs have to be fully charged, after used. -
Page 21: Maintenance
Use only AEG accessories and AEG spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. Please state the Article No. - Page 24 31 Gilby Road, Mount Waverley, VIC, 3149, Australia Techtronic Industries N.Z. Limited Unit C, 70 Business Parade South, Highbrook, Auckland 2013, New Zealand AEG is a registered trade mark used under license from AB Electrolux (publ). 961096680-01A © 2020 Techtronic Cordless GP.
Need help?
Do you have a question about the MMS18SBL and is the answer not in the manual?
Questions and answers