hit counter script
AEG FSK74747P User Manual
Hide thumbs Also See for FSK74747P:

Advertisement

Quick Links

aeg.com/register
EN User Manual | Dishwasher
FSK74747P
aeg.com\register

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FSK74747P and is the answer not in the manual?

Questions and answers

Summary of Contents for AEG FSK74747P

  • Page 1 EN User Manual | Dishwasher FSK74747P aeg.com\register...
  • Page 2: Table Of Contents

    Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................5 4. PRODUCT DESCRIPTION................7 5.
  • Page 3 • Children of less than 3 years of age should be kept away from the appliance unless continuously supervised. • Children should be supervised to ensure that they do not play with the appliance. • Keep detergents away from children. •...
  • Page 4: Safety Instructions

    • If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
  • Page 5: Installation

    parts related to door assemblies, printed WARNING! circuit boards, electronic displays, pressure switches, thermostats and Dangerous voltage. sensors, software and firmware including reset software. The following spare parts 2.4 Use are available for at least 10 years after the • Do not put flammable products or items model has been discontinued: door hinge that are wet with flammable products in, and seals, other seals, spray arms, drain...
  • Page 6 Authorized Service Centre to replace it with www.youtube.com/electrolux the new one. www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher min. 550 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
  • Page 7: Product Description

    4. PRODUCT DESCRIPTION 4.1 Beam-on-Floor Ceiling spray arm Upper spray arm The Beam-on-Floor is a light that is displayed Lower spray arm on the floor below the appliance door. Filters • A red light comes on when a programme starts. It remains on for the duration of the Rating plate programme.
  • Page 8: Programme Selection

    Display A. ECOMETER B. Indicators MY TIME program selection bar C. Time indicator Option buttons (EXTRAS) 5.2 ECOMETER AUTO Sense program button 5.1 Display The ECOMETER indicates how the programme selection impacts energy and water consumption. The more bars are on, the lower the consumption is.
  • Page 9 normal soil. This is the standard is activated, the wash pump works quietly at a lower speed. Due to the low speed, the programme for test institutes. programme duration is longer. 6.2 AUTO Sense ExtraPower The AUTO Sense programme automatically adjusts the dishwashing cycle to the type of ExtraPower improves the dishwashing load.
  • Page 10 Programme Dishwasher Degree of Programme phases EXTRAS load soil 2h 40min Crockery, cut‐ Normal to • Prewash • ExtraPower lery, pots, pans heavy, dried-on • Dishwashing 60 °C • GlassCare • Intermediate rinse • Final rinse 60 °C • Drying •...
  • Page 11: Basic Settings

    In your request, include the product number Information for test institutes code (PNC) from the rating plate. To receive the necessary information for For any other questions regarding your conducting performance tests (e.g. according dishwasher, refer to the service book to: EN60436 ), send an email to: provided with your appliance.
  • Page 12 4. Press OK to confirm the setting. How to enter setting mode • The new setting is saved. • The appliance returns to the basic You can enter setting mode before starting a settings list. programme. You cannot enter setting mode while the programme is running.
  • Page 13 Regardless of the type of detergent used, additional 4 litres and the total energy set the proper water hardness level to consumption of a programme by additional 2 keep the salt refill indicator active. Wh. The rinsing of the softener ends with a complete drain.
  • Page 14: Before First Use

    CAUTION! If children have access to the appliance, we advise to deactivate AirDry. The automatic opening of the door may pose a danger. When AirDry opens the door, Beam-on- Floor might not be completely visible. To see if the programme is complete, look at the control panel.
  • Page 15: Daily Use

    8.2 How to fill the rinse aid dispenser 4. Carefully shake the funnel by its handle to get the last granules inside. 5. Remove the salt around the opening of the salt container. CAUTION! The compartment (B) is for rinse aid only. Do not fill it with detergent.
  • Page 16 9.1 Using the detergent • The light related to the selected programme is on. • The ECOMETER indicates the level of energy and water consumption. • The display shows the programme duration. 2. Activate applicable EXTRAS if desired. 3. Close the appliance door to start the programme.
  • Page 17 cycle, the sensors operate several times and shows the remaining duration of the the initial program duration can decrease. programme. After closing the door, the wash cycle resumes from the point of interruption. 9.5 How to delay the start of a If you open the door during the delay start programme countdown, the countdown is paused.
  • Page 18: Hints And Tips

    10. HINTS AND TIPS 10.1 General 10.2 Using salt, rinse aid and detergent Follow the hints below to ensure optimal cleaning and drying results in daily use and to • Only use salt, rinse aid and detergent protect the environment. designed for dishwasher.
  • Page 19: Care And Cleaning

    4. When the programme is completed, • Do not wash in the appliance items that adjust the water softener according to the can absorb water (sponges, household water hardness in your area. cloths). 5. Adjust the released quantity of rinse aid. •...
  • Page 20 11.5 Cleaning the filters 2. Press and hold simultaneously The filter system is made of 3 parts. for about 3 seconds. The indicators flash. The display shows the programme duration. 3. Close the appliance door to start the programme. When the programme is complete, the indicator is off.
  • Page 21 CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.6 Cleaning the lower spray arm We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes. Clogged holes can cause unsatisfactory washing results.
  • Page 22 4. To install the spray arm back, press the spray arm upwards and simultaneously turn it counterclockwise until it locks into place. 11.7 Cleaning the upper spray arm We recommend to clean the upper spray arm regularly to prevent soil from clogging the holes.
  • Page 23: Troubleshooting

    2. Move the upper basket to the lowest level 5. To install the spray arm (C) back, insert to reach the spray arm more easily. the mounting element (B) in the spray 3. To detach the spray arm (C) from the arm and fix it in the delivery tube (A) by delivery tube (A), turn the mounting turning it clockwise.
  • Page 24 Problem and alarm code Possible cause and solution The appliance does not fill with wa‐ • Make sure that the water tap is open. ter. • Make sure that the pressure of the water supply is not too low. For this The display shows i10 or i11.
  • Page 25 Problem and alarm code Possible cause and solution Small leak from the appliance door. • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable). • The appliance door is not centred on the tub. Adjust the rear foot (if ap‐ plicable).
  • Page 26 12.2 The dishwashing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and the basket loading leaf‐ let. • Use more intensive washing programme. • Activate the ExtraPower option to improve the washing results of a selected programme.
  • Page 27: Technical Information

    Problem Possible cause and solution Limescale deposits on the tableware, • The level of salt is low, check the refill indicator. on the tub and on the inside of the • The cap of the salt container is loose. door. •...
  • Page 28: Environmental Concerns

    rating plate of the appliance. Refer to the For more detailed information about the chapter "Product description". energy label, visit www.theenergylabel.eu. 14. ENVIRONMENTAL CONCERNS appliances marked with the symbol with Recycle materials with the symbol . Put the the household waste. Return the product to packaging in relevant containers to recycle it.
  • Page 32 117839443-A-102024...

Table of Contents