Page 1
ÖKO_FAVORIT 5070 Dishwasher User Instructions...
Page 2
Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
• Keep all packaging away from children. • Keep all detergents in a safe place out of children’s reach. • The water in your dishwasher is not suitable for drinking. If there are still remnants of detergent in the appliance, there is risk of burns! •...
• Only use detergents specifically designed for use in domestic dish- washers. • Do not put solvents in the dishwasher. There is a risk of an explosion! • The leak prevention system provides reliable protection from damage due to water leaks. For this system to function the following prereq- uisites must be met: –...
Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are harmless to the environment and can be recy- cled. • Plastic parts are marked with standard international abbreviations: –...
Operating instructions Appliance Features and Control Panel Top Spray Nozzle Rubber Seal for Connecting the Water Feed to the Upper Spray Spray Arms Container for Salt Container for Rinse Aid Detergent Dispenser Rating Filters Plate...
The Control Field comprises the ON/OFF button and the programme buttons with LED indicators. Softener and Function Button: In addition to the wash programme marked, the dishwasher's water softener is adjusted using a combina- tion of these buttons. The Indicators have the following meanings:...
Operating instructions Adjust the Water Softener To avoid the scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content, water. The dish- washer therefore has a built-in water softener, in which tap water from a hardness of 4 °d (German degree) is softened with the aid of special...
This is not a cause for concern, the water will be pumped out at the start of the next wash programme. 5. Clean any salt remnants on the container opening. 6. Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water. Dull glasses may result. Operating instructions...
– Prior to using the dishwasher for the first time – When the RINSE AID indicator on the control panel is illuminated. The rinse aid container is on the inside of the dishwasher door. 1. Open the door 2. Turn the lid of the container ¼...
In Daily Use • Check the salt and rinse aid levels. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes • Start the wash programme...
– To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack are of limited suitability: • Only wash stoneware in the dishwasher if it is specifically marked as being dishwasher- safe by the manufacturer.
2. Place short knives, forks and spoons in the grid insert with their handles pointing downwards. To make the removal of cutlery easier, on some dishwasher models it is possible to open the cutlery rack. If you use the grid insert then the cutlery rack cannot be opened.
Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1. Slightly lift the right plate insert.
Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. •...
Operating instructions Adjusting the Height of the Upper Rack With Raised Upper Rack With Lowered Upper Rack The height of the rack can also be adjusted when the rack is loaded. Lowering the Upper Rack: 1. Pull out the upper rack to the stop. 2.
Filling with Detergent Use only dishwasher detergent. Fill with Detergent: – Prior to the start of a wash programme (not for the Pre Wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer’s dosing and storage recommenda- tions given on the detergent packaging.
Operating instructions Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...
Coffee All Dish Types Service with delicate glasses • lightly Used dishes soiled that are being collected in the dishwasher for washing later. QUICK 50 °C PRE WASH Pre Wash Main Wash Intermediate Rinse Final Rinse 30 min. 10 min.
Operating instructions Start the Wash Programme 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button. The ON/OFF button indicator illuminates.
• The dishes will dry quicker if you open the door fully and then leave it slightly ajar, when the programme has finished. • Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.
Blocked filters will give poor wash results. 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter, and remove.
Page 25
During this process ensure that the flat filter does not protrude above the base of the wash- ing compartment. The dishwasher must not be used without filters under any circum- stances. Operating instructions...
Operating instructions What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
The dishes are wet and dull. – Rinse aid was not used. – The rinse aid container is empty. Possible Cause The door of the dishwasher is not closed properly. Mains plug is not plugged in. Insert mains plug. House fuse is defective.
1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door on the right. 850 x 600 x 600 (H x W x D in mm) 54 Kg 820 –...
Notes for Test Institutes The salt container for the water softener and the rinse aid container must be completely full prior to the test. Test Standard: Comparative Programme: Full Load: Detergent Dosing: Half Load: Detergent Dosing: Rinse Aid Setting: Example Loading Arrangement: Upper rack (lower and upper positions): Bottom rack with cutlery basket EN 5O 242 Normal BIO 50 °C for full and half load...
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the...
Free-Standing Appliances • can be set up as stand-alone without additional installation. If the dishwasher is set up next to a gas or coal cooker, a heat-insu- lating, non-flammable plate must be mounted between the dish- washer and the cooker, flush to the top edge of the work surface (depth 57.5 cm).
Page 32
(4) and remove the bracket at an angle to the rear (5). If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted. The plinth on free-standing appliances is not adjustable. • Free-standing appliances can be outfitted with a décor panel to...
Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the return of wash water into the drinking water system and comply with the appli- cable plumbing regulations. • The dishwasher should be connected to a cold water supply.
Installation and Connection Instructions Water drain Drain hose The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose: – Maximum permitted height: 1 metre. – Minimum required height 30 cm above the lower edge of the machine.
Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the drain pump switches on. By this means water can neither escape nor overflow. The remaining water in the appliance is automatically pumped out.
Page 36
Installation and Connection Instructions • The wire coloured green and yellow must be connected to the termi- nal marked with the letter “E“ or by the earth symbol green and yellow. • The wire coloured blue must be connected to the terminal “N“ or col- oured black.
Connections The water inlet and drain hoses, as well as the mains cable must be con- nected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation.
GUARANTEE CONDITIONS Great Britain Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar docu- mentation.
Guarantee Conditions Other Countries Weitere Kundendienststellen im Ausland In diesen Ländern gelten die Garantiebedingungen der örtlichen Part- ner. Diese können dort eingesehen werden. Further after-sales service agencies overseas In these countries our AEG agents’ own guarantee conditions are appli- cable. Please obtain further details direct. Autres agences étrangères assurant le service après-vente Dans ces pays, les conditions de garantie des concessionnaires de la région sont valables.
SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area. When you contact the Service Centre they will need the following information: Your name &...
Need help?
Do you have a question about the 5070 and is the answer not in the manual?
Questions and answers