Allow the cabinet to run for a period of 24 hours whenever the temperature setting is changed. This will allow the temperature to stabilise inside the cabinet. Once set, the temperature display shows "- -" until the temperature inside the fridge reaches -1°C or below. Electrolux 818 19 37-01/5...
Fast-freezing is automatically switched of apporox 50 hours after the button has been pressed. Fast-freezing can be discontinued by pressing the fast-freezing button once again. The yellow fast-freezing lamp remains lit as long as the fast-freezing button is engaged. Electrolux 818 19 37-01/5...
Release the ice cubes by twisting the ice tray. If ice cubes are kept for a long time, they will dry out and the taste is affected. Thus, throw away old ice cubes and prepare new ones when needed. Electrolux 818 19 37-01/5...
The ventilation grille can be removed, e.g. to wash the grille. Make sure the door is open when removing the ventilation grille. Unsnap the upper edge of the grille by pulling outward/downward. Then pull the grille straight out to completely remove it. Electrolux 818 19 37-01/5...
When all the ice has melted, clean and wipe the making it live. cabinet dry, then push the drain spout back in place. Switch on the cabinet and replace the frozen foodstuff. Electrolux 818 19 37-01/5...
The compressor operates continuously. Set a warmer temperature. Make sure that the door is completely closed and that the insulating strip is complete and clean. The temperature where the cabinet is placed is above normal room temperature. Electrolux 818 19 37-01/5...
In the event of your appliance requiring service, or See Guarantee Conditions on the Registration Card. if you wish to purchase spare parts please contact Customer Care Department your local Electrolux Service Force Centre by telephoning: For general enquiries concerning your Electrolux XXXXXXXXXXX...
Affix the supplied plastic peaces at the rear of the cabinet. Cleaning Wash the inside of the cabinet using lukewarm water, a mild washing-up detergent and a soft cloth. Remove the transport supports Remove the transport supports placed along the door sides inside the hinges Electrolux 818 19 37-01/5...
The power plug must be accessible after installation of the cabinet. When two appliances are placed beside each other, the distances enclosed in the plastic wrapping should be glued between the appliances. As shown in the illustration. Electrolux 818 19 37-01/5...
9. Put the cabinet in position. Check that it stands straight. See the section "Positioning the cabinet". Electrical connection Connect the cabinet to a grounded electrical outlet. Voltage: 230 V. Fuse: 10 A. Refer to the rating plate on the left inside the cabinet. Electrolux 818 19 37-01/5...
Need help?
Do you have a question about the EUC2700 and is the answer not in the manual?
Questions and answers