Page 1
ÖKO_FAVORIT 60850 i Dishwasher User Instructions...
Page 2
Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
Operating Instructions OPERATING INSTRUCTIONS Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Placing into Operation •...
• If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG customer service) must be changed by a service engineer authorised by AEG. • Never unplug the appliance by pulling on the cable, always pull the plug.
Operating Instructions • Do not sit or stand on the open door, the appliance may tip over. • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: switch off the fuse(s) or unscrew them.
Operating Instructions Appliance Features and Control Panel Top Spray Arm Rubber Seal for Connecting the Water Feed to the Spray Arm Spray Arms Water hardness switch Container for Special Salt Container for Detergent Container for Filters Rating Plate Rinse Aid...
Operating Instructions Control Panel Set Start Delay Function Buttons Door Handle Indicators Function Buttons Control Panel Multi-Display The control panel consists of the ON/OFF button A and the pro- gramme buttons with LED displays. Function buttons: In addition to the stated wash programme the fol- lowing functions can also be set using these buttons: Function Button 1 Adjust the water softener...
Operating Instructions Prior to using for the first time Prior to using for the first time, remove all the clips with which the dish racks are secured for transport. Then perform the following steps: 1. Adjust the water softener 2. Filling with Special Salt for the Water Softener 3.
Operating Instructions 1) (°d) German degree, measure of the hardness of water 2) [mmol/l] millimol per litre, international unit for the hardness of water 3) On this setting the length of the dishwashing cycle may be slightly longer. *) Factory setting Set water softener Using the table as a guide, adjust the water softener to that which cor- responds to the hardness of the water in your area:...
Operating Instructions Special salt for the water softener If the water hardness in your area is less than 4 °d, then the water in your dishwasher does not need to be softened and you do not need to use special salt or salt substitute. Water can be softened in one of two ways: •...
Operating Instructions If the water softener is electronically set at “1” for the purpose of using detergent that includes special salt, the special salt indicator is deacti- vated. Adding special salt If you are using dishwasher detergent and special salt separately, add the special salt: –...
Operating Instructions Filling with Rinse Aid Rinse aid ensures that your dishes gleam and are free from spots, and that you glasses are clear. Use only branded rinse aid for dishwashers. Never fill the rinse aid con- tainer with any another substance (e.g. concentrated vinegar). This would damage the appliance.
Operating Instructions Adjusting Rinse Aid Dosing As the dishes are washed rinse aid is released from the dispenser into the wash water. The dose is factory set at 4, and can be adjusted from 1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery.
Operating Instructions In Daily Use • Is it necessary to refill with special salt or rinse aid? • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes •...
Operating Instructions – To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long, pointed items of cutlery are a hazard if placed in the cutlery basket, particularly to children (see Safety Instructions). They should therefore be placed in the upper rack.
Page 18
Operating Instructions If you use the grid insert, it is not possible to open the cutlery basket. To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 1.
Operating Instructions Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rack. Your dishwasher has one of the following four types of lower rack: Type 1: None of the plate inserts in the lower rack can be removed Type 2: The right-hand plate inserts in the lower rack can be folded over to the left To ease the loading of large items,...
Page 20
Operating Instructions Type 3: The right-hand plate inserts in the lower rack can be folded across one another To ease the loading of large items, the two right-hand plate inserts in the lower rack can be folded across one another. Type 4: The two rear plate inserts in the lower rack can be folded across one another To ease the loading of large items,...
Operating Instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Operating Instructions Adjusting the Height of the Upper Basket Maximum Height of the Dishes in the Upper Basket Lower Basketk With upper basket raised 22 cm 31 cm With upper basket lowered 24 cm 29 cm The height of the basket can also be adjusted when it is loaded. Lowering the Upper Basket: 1.
Operating Instructions Filling with Detergent Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging.
Operating Instructions Use of "3 in 1"/ Combi Detergent Tablets General Advice These products are tablets with combined detergent/rinse-aid and salt functions. 1. Before using these products you should first check that the water hard- ness in your supply is compatible with the use of these products as per the detergent manufacturers instructions (on the product packaging).
Operating Instructions Concentrated Detergent Based on their chemical composition, dishwasher detergents can be split into two basic types: – conventional, alkaline detergents with caustic components – low alkaline concentrated detergents with natural enzymes. The use of 50 °C wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...
Operating Instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Coffee Type of Dinner Service and Cooking Utensils Service and Dishes Dessert Dishes with non-temperature resistant with delicate In Addition dishes glasses Type of...
Operating Instructions Starting a dishwashing cycle 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. 2. Turn on the tap fully. 3. Close the door. 4.
Operating Instructions Interrupting the dishwashing cycle by opening the dishwasher door Hot steam may escape when the door is opened. There is a risk of scald- ing. Open the door carefully. 1. Open the door of the dishwasher. The dishwashing cycle will stop. 2.
Operating Instructions Changing the start delay: As long as the dishwashing cycle has not started, you can still change the start delay set by pressing the DELAY TIMER button. Cancelling the start delay: As long as the dishwashing cycle has not begun you are able to cancel the start delay.
Operating Instructions Emptying the Dishwasher • Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing them from the appliance. • Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.
Operating Instructions 4. Take hold of the coarse/fine filter (1/ 2) by the handle with the hole and remove from the microfilter (3) 5. Clean all filters thoroughly under running water. 6. Remove the flat filter (4) from the base of the washing compartment and clean both faces thoroughly 7.
Operating Instructions ...Error messages are displayed. If any of the indicators in the control panel, as listed in the table below, are flashing or are illuminated, you can probably rectify the fault your- self. Malfunction Possible cause Remedy The tap is blocked or furred Clean tap with lime-scale The tap is turned off.
Operating Instructions ...problems occur during use of the dishwasher. Malfunction Possible Cause Remedy The door of the dishwasher is Shut the door. not closed properly. Mains plug is not plugged in. Insert mains plug. The programme does House fuse is defective. Replace fuse.
Operating Instructions There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosing. – The detergent may be the cause. Contact the detergent manufac- turer’s customer advisor.
Operating Instructions Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table).
Installation and Connection Instructions INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:...
Installation and Connection Instructions • Depending on type, the dishwasher is to be installed as follows: Dishwashers That Can Be Integrated (see installation template supplied) The door of the appliance can be fitted with a wooden furniture door with the following dimensions: Width 587mm 591 –...
Page 38
Installation and Connection Instructions If the dishwasher is installed underneath a kitchen work surface, the original work surface of the dishwasher is to be removed as follows: 1. Unscrew the screws from the posi- tioning plates on the back (1). 2.
Installation and Connection Instructions Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max.
Installation and Connection Instructions The following section is only applicable to dishwashers that have a safety valve on the threaded hose fitting for the tap: Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap.
In the case that you wish to hang the drain hose in a wash basin, use a detachable hose elbow. You can obtain this from AEG customer service under spare part number ET 646 069 190. 1. Fit the elbow to the drain hose.
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve in the appliance immediately interrupts the inflow of water and the drain pump is activated.
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation;...
In diesen Ländern gelten die Garantiebedingungen der örtlichen Part- ner. Diese können dort eingesehen werden. Further after-sales service agencies overseas In these countries our AEG agents’ own guarantee conditions are appli- cable. Please obtain further details direct. Autres agences étrangères assurant le service après-vente Dans ces pays, les conditions de garantie des concessionnaires de la région sont valables.
Service SERVICE In the section "What to do, if..." the most important sources of faults that you can rectify yourself are summarised. If, nevertheless, you call in customer service to resolve a problem listed in these instruction, or because of an error made in operating the appliance, the customer service engineer’s visit is not free of charge, even during the warranty period.
Need help?
Do you have a question about the ÖKO FAVORIT 60850 i and is the answer not in the manual?
Questions and answers