If you require guidance in the use of the appliance or require further information on Electrolux Products, please contact our Customer Care Department. For general enquiries concerning your Electrolux appliance or for further information, visit our website at http:\\www.electrolux.co.uk...
Refer to your local • When installed between adjoining wall cabinets the Electrolux Service Force Centre. Always insist on wall cabinets must not overhang the hob. genuine spare parts. • If the room where the hood is to be used contains a...
YOUR APPLIANCE Ø 100 OPERATING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing.
Page 5
The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Recirculation The cooker hood is supplied specified for use in the recirculation mode with the charcoal filter fitted. In the recirculation mode contaminated air is passed through the charcoal filter to be purified and recirculated into the kitchen through a recirculation...
MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent.
Charcoal Filter The charcoal filter cannot be cleaned. The filter should be replaced at least every three months or more frequently if the hood is used more than three hours per day. To Remove/Replace the Charcoal Filter Remove the metal inlet grille. Carefully turn the disk (C) anti-clockwise and remove the the charcoal filter (B) from the motor support (A) as illustrated opposite.
SERVICE AND SPARE PARTS If you require an engineer or spare parts For general assistance with your appliance or contact your local Service Force Centre by for further information on Electrolux products telephoning: please contact our Customer Care Department. Customer Care Department,...
GUARANTEE CONDITIONS We, Electrolux, undertake that if within twelve months of the date of the purchase this Electrolux built-in appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will,...
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT: 150mm WIDTH: 598mm DEPTH: 498mm DEPTH WITH VISOR OPEN: 510mm WEIGHT GROSS: 8,3 kg NET: 7,3 kg ELECTRICAL SUPPLY: Voltage (50Hz) 220-240 V POWER CONSUMPTION:...
INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood.
Clearance Height A minimum clearance height of 650mm (25 1/2 ”) is required when installed above a built-in electric hob, or 700mm (27 1/2 ”) when installed above a built-in gas hob. A minimum clearance height of 685mm (27”) is required when installed above a slot-in electric oven, or 787mm (30 1/2 ”) when installed above a slot-in gas oven.
Page 13
Venting The hood is more effective when used in the extraction setting (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of 100mm (4”) minimum. The ducting used must be manufactured from fire retardant material which should conform to the relevant British Standard or DIN4102-B1.
Need help?
Do you have a question about the EFT 615 and is the answer not in the manual?
Questions and answers