15. INSTALLATION ............31 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...
ENGLISH 1. SAFETY INFORMATION Before the installation and use of the appliance, careful- ly read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use cau- ses injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali- fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) •...
ENGLISH Water connection sene, spot removers, turpentine, wax- es and wax removers, wash them in • Make sure not to cause damage to the hot water with an extra amount of de- water hoses. tergent. • The appliance is to be connected to •...
• Disconnect the appliance from the 2.5 Service mains supply. • Contact the Service to repair the ap- • Cut off the mains cable and discard it. pliance. We recommend only the use • Remove the door catch to prevent of original spare parts.
ENGLISH 4. PRODUCT DESCRIPTION Worktop Feet for the appliance level Detergent dispenser Water drain hose Control panel Water inlet valve Door handle Mains cable Rating plate Transit bolts Drain pump Feet for the appliance level 4.1 Accessories Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of...
5. CONTROL PANEL Koch/Bunt + Vorwäsche Pflegeleicht + Vorwäsche Leichtbügeln Feinwäsche Wolle/Seide 20 Min. - 3 kg On/Off button (Ein/Aus) The AUTO Stand-by function automati- cally deactivates the appliance to de- Programme knob crease the energy consumption when: Display •...
ENGLISH Dryness levels symbols: Iron dry Store dry Extra dry The display symbols: Washing phase Drying phase Extra rinse Child lock You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. If the programme is completed but the symbol stays on: •...
10 www.aeg.com The display shows only the spin 5.6 Time save button speeds available with the set programme. Press the button to decrease the programme duration. • Deactivate the spin phase. • Press one time to set 'Shortened dura- • Activate the 'Rinse Hold' function. Set tion' for items with daily soil.
ENGLISH • After you press the Start/Pause button , all the buttons and the pro- gramme knob are deactivated. 6. PROGRAMMES Programme Type of load Cycle Functions Temperature max. weight of load description WASHING PROGRAMMES Koch/Bunt White and coloured Wash SPIN REDUC- 95°...
Page 12
12 www.aeg.com Programme Type of load Cycle Functions Temperature max. weight of load description Wolle / Seide Machine washable Wash SPIN REDUC- wool. Hand washable Rinses TION wool and delicate Short spin RINSE HOLD 40° - Cold fabrics with «hand washing»...
Page 13
ENGLISH Programme Type of load Cycle Functions Temperature max. weight of load description Energiesparen White and fast col- Wash SPIN REDUC- oured cotton with Rinses TION normal soil. Long spin RINSE HOLD 60° - 40° For cotton economy EXTRA RINSE programmes you can TIME SAVE set only the Extra...
ENGLISH Programme Energy con- Water con- Programme sumption sumption duration (KWh) (litres) (minutes) Cottons 60° 1.60 For the du- ration of the Cotton Energy Saving Pro- 1.04 pro- gramme 60° grammes, Cottons 40° please refer to the dis- Synthetics 40° 0.60 play on the Delicates 40°...
16 www.aeg.com Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 9.2 Filling the detergent and additives The detergent compartment for the prewash phase, the soak programme and for the stain function.
ENGLISH Check the position of the flap Pull out the detergent dispenser un- til it stops. Press the lever down to remove the dispenser. To use powder detergent, turn the flap up. To use liquid detergent, turn the flap down. With the flap in the position DOWN: –...
18 www.aeg.com When the countdown is completed, Press button to start the pro- the programme starts automatically. gramme. The indicator of button is on. Before you press button start the appliance, you can can- The drain pump can operate for...
ENGLISH • The door lock symbol goes off. – The door stays locked. • Press button – You must drain the water to open the to deactivate the ap- door. pliance. After five minutes from the end of the programme, the energy To drain the water: saving function automatically deacti- If necessary, decrease the spin...
20 www.aeg.com The display shows a minimum time • The acoustic signals operate. value. • In the display comes on. Set time value • The indicator of the Start/Pause but- goes off. • Each time you press this button the time value increases by 5 minutes.
Page 21
ENGLISH Set drying time value The set dryness level sym- bol stays on. The others level symbols • After some seconds the display shows go off. the total duration of the cycles. The door locked symbol Final time value (washing comes on.
22 www.aeg.com To remove the fluff inside the drum, • Press at the same time button set a special programme: button to activate the cleaning • Empty the drum. function until the display shows CLE. • Clean the drum, the gasket and the •...
ENGLISH • mmol/l (millimol for each litre - inter- • Clarke degrees. national unit for the hardness of wa- ter). Water hardness table Water hardness Level Type °dH °T.H. mmol/l Clarke soft 0-15 0-1.5 medium 8-14 16-25 1.6-2.5 10-16 hard 15-21 26-37 2.6-3.7...
24 www.aeg.com 13. CARE AND CLEANING WARNING! CAUTION! Do not use alcohol, solvents or chemical products. Disconnect the appliance from the mains supply before you clean it. 13.3 Maintenance wash 13.1 Descaling With the low temperature programmes it is possible that some detergent stays in The water we use contains limescale.
ENGLISH 13.6 Detergent dispenser To clean the dispenser: Press the lever. Pull the dispenser out. Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put back the dispenser in the recess. •...
26 www.aeg.com To clean the drain pump: Open the drain pump door. Pull the flap out to remove it. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull for- ward the drainage duct to let the water flow out.
ENGLISH Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. Put the flap back and close the drain pump door. 13.8 The inlet hose filter and •...
28 www.aeg.com Put the drainage duct back and close the Close the water tap. drain pump flap. Remove the water inlet hose When you drain the water with the emer- Put the two ends of the inlet hose in gency drain procedure, you must acti-...
Page 29
ENGLISH Problem Possible cause Possible solution The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain Clean the filter of the drain pump is blocked.
Page 30
30 www.aeg.com Problem Possible cause Possible solution Leakages from the drain Make sure that the drain pump pump. filter is tight. The water drain hose is Make sure that the water inlet damaged. hose has no damages. You cannot open...
ENGLISH Problem Possible cause Possible solution You have set a wrong Set additional drying time. dryness level or drying time. There is a big The fabrics washed in the previ- quantity of fluff in ous cycle released fluff of a dif- the drum.
Page 32
32 www.aeg.com Remove the cardboard top. Remove the polystyrene packaging materials. Remove the internal film. Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum. Put one of the polystyrene packag- ing elements on the floor behind the appliance.
Page 33
ENGLISH Remove the polystyrene protection from the bottom. Pull up the appliance in vertical po- sition. Remove the power supply cable and the drain hose from the hose hold- ers. Remove the three bolts. Use the key supplied with the appliance. Pull out the plastic spacers.
34 www.aeg.com WARNING! We recommend that you keep Remove all the packaging and the packaging and the transit the transit bolts before you install bolts for when you move the ap- the appliance. pliance. 15.3 Positioning and levelling • Install the appliance on a flat hard floor.
ENGLISH • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Con- tact the service centre for the re- placement of the inlet hose.
Page 36
36 www.aeg.com • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole.
ENGLISH 16. ENVIRONMENT CONCERNS Recycle the materials with the appliances. Do not dispose symbol . Put the packaging in appliances marked with the symbol applicable containers to recycle it. with the household waste. Return the Help protect the environment and product to your local recycling human health and to recycle waste facility or contact your municipal...
Need help?
Do you have a question about the L 75480 WD and is the answer not in the manual?
Questions and answers