Philips DFA 888 Manual

Table of Contents

Need help?

Do you have a question about the DFA 888 and is the answer not in the manual?

Page 3: Installation
Button not pressed: 'COAX' position (connection via the English coaxial socket Button pressed in: 'OPT' position (connection via the glass-fibre socket a ) . INTRODUCTION 'DIGITAL CD OPT' glass-fibre socket This amplifier represents a new step forwards in digital sound For connection of a digital output of a Compact Disc player technology.
Page 4: Operating Elements And Their Function
OPERATING ELEMENTS AND THEIR FUNCTION This should preferably be set at a lower position to prevent damage to the loudspeakers. 2 . Switch on the amplifier using the 'ONIOFF' switch Figure 2 The lighting around the volume control and above the 'ONIOFF' switch 'ON/OFF' switch lights up.
Page 5: General Information
Note: GENERAL INFORMATION If the 'SOURCE DIRECT' switch is pressed: - the 'SOURCE DIRECT' indicator lights up. Loudspeaker connection - the 'BASS/TREBLE' controls are switched off. Loudspeakers must be connected in pairs to the 'SPEAKERS' loudspeaker connections (impedance 4 to 16 ohms, if only released after you have finished, by pressing the switch once system A or system B is used or loudspeakers with an imped- more.
Page 6: Technical Data
TECHNICAL DATA (Subject to alteration) Power output acc. to FTC at 8 ohm load < (20-20.000 Hz, D 0.03%): 75 W continuous sine wave at 4 ohm load (20-20.000 Hz, D 0.05%) : 90 W continuous sine wave < Power output acc. to IEC at 8 ohm load <...