EPSON PowerLite Quick Setup Unpack the projector Your projector comes with the following items: Remote control Set up the remote control Pull out the insulating tape to remove it from the battery holder. The remote control is ready for use.
Page 2
Connect your equipment The projector has 4 types of connections, as shown below. Each one is color-coded and requires a different type of cable (not included). You can connect up to 4 video sources and use the remote control to switch from one to the other.
Choosing a location The easiest way to set up your projector is to place it on a table in front of your screen or wall, or on a high shelf behind you. See the User’s Guide for other ways of setting up the projector.
Power light Turn on your equipment. (If you are connecting to a computer, don’t turn it on yet. Wait until you’ve turned on the projector.) Press the You hear a beep, the projector lamp comes on in about 45 seconds.
Where to get help Telephone Support Services ® To use the EPSON enter the PIN on the included EPSON PrivateLine Support card. This service is available 6 to 6 duration of your warranty period. You may also speak with a projector support specialist by dialing one of these numbers: U.S.:...
Remove the clear film covering the infrared receivers. EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite and PrivateLine are registered trademarks and EPSON Store is a service mark of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners.
Need help?
Do you have a question about the PowerLite Home 10 and is the answer not in the manual?
Questions and answers