Advertisement
Quick Links
USB Charging Kit
Groundsmaster
Model No. 31984
Installation
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the cutting unit.
4.
Shut off the engine and remove the key.
5.
Disconnect the battery; refer to the electrical
system maintenance section of your Operator's
Manual.
2
Installing the Kit
Parts needed for this procedure:
1
USB port
4
Plug
Procedure
1.
Remove the existing plugs
sides of the parking-brake cover.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3200 or 3300 Series Traction Unit
(Figure
1) from both
Register at www.Toro.com.
Figure 1
1. Plugs (4 total—2 shown)
2.
Remove the parking-brake cover from the
machine.
3.
Drill a hole (3 cm or 1-3/16 inches) into the front
of the cover as shown in
Original Instructions (EN)
All Rights Reserved *3434-891* A
Printed in the USA
Form No. 3434-891 Rev A
Installation Instructions
Figure 2
g301501
Advertisement
Related Manuals for Toro 31984
Summary of Contents for Toro 31984
- Page 1 Form No. 3434-891 Rev A USB Charging Kit Groundsmaster ® 3200 or 3300 Series Traction Unit Model No. 31984 Installation Instructions Installation Preparing the Machine No Parts Required Procedure Park the machine on a level surface. Engage the parking brake.
- Page 2 g301500 Figure 4 1. Plug (4) Use 4 plugs to secure the parking-brake cover to the machine (Figure g301502 Figure 2 1. 6.8 cm (2.7 in) 2. 2.5 cm (1 in) Remove the jam nut from the USB port. Connecting the Battery Use the previously-removed jam nut to secure the USB port to the parking-brake cover (Figure...
Need help?
Do you have a question about the 31984 and is the answer not in the manual?
Questions and answers