Honeywell Voyager 1250g Manual

Getting Started

Power Supply Assembly (if included)

Connecting the Scanner

USB:

Keyboard Wedge:

Reading Techniques

Standard Product Defaults

The following bar code resets all standard product default settings.

Standard Product Defaults

RS485 Interface

The RS485 interface defaults to port 5B. If you have an IBM POS terminal using port 9B, scan the appropriate code below to program the terminal, then power cycle the cash register.

IBM Port 9B HHBCR-1
Interface

IBM Port 9B HHBCR-2
Interface

Note: For additional RS485 interface selections, see the User's Guide for your product at our website, www.honeywellaidc.com.

Keyboard Country

Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) from the end of this document, then the Save bar code to program the keyboard for your country. As a general rule, the following characters are not supported by the scanner for countries other than the United States:
@ | $ # { } [ ] = / ' \ < > ~.

Program Keyboard Country

Save

Reread Delay

This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against accidental rereads of the same bar code.

Medium Reread Delay

Suffix

If you want a carriage return after the bar code, scan the Add CR Suffix bar code. To add a tab after the bar code, scan the Add Tab Suffix bar code. Otherwise, scan the Remove Suffix bar code to remove the suffixes.

Add CR Suffix

Add Tab Suffix

Remove Suffix

Add Code ID Prefix to all Symbologies

Scan the following bar code if you wish to add a Code ID prefix to all symbologies at once.

Add Code ID Prefix To All Symbologies
(Temporary)
Note: For a complete list of Code IDs, see the User's Guide for your product at our website, www.honeywellaidc.com.

Data Format Editor Instructions

The following are abbreviated instructions for entering a data format. For complete instructions refer to your User's Guide, available at our website, www.honeywellaidc.com.

1. Scan theEnter Data Format symbol.
2. Primary/Alternate Format: scan0 for Primary Format
3. Terminal Type: scan099 for any terminal type
4. Code I.D.: scan99 for any bar code type
5. Length: scan9999 for any length bar code.
6. Editor commands: use the Programming Chart that follows.
7. ScanSave to save your entries.
   
   Enter Data Format
   
   Clear All Data Formats
   
   Save

Programming Chart

EZConfig-Scanning

To access additional features for the scanner use EZConfigScanning, an online configuration software tool, available from our website at www.honeywellaidc.com.

Technical Assistance

Contact information for technical support, product service, and repair can be found at www.honeywellaidc.com.