Koninklijke Philips Electronics N.V. or their respective owners. TP Vision Netherlands B.V. reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. PHILIPS and the PHILIPS’ Shield Emblem are used under license from Koninklijke Philips Electronics N.V.
& Notes: drivers. • Figures can deviate due to the different set executions. Table 2-1 Described Model Numbers and Diversity Mechanics Block Diagrams Schematics 32PFL3008D/78 10.1 10.4 10.5 10.6 11.1 32PFL3008D/77 10.1 10.4 10.5...
Technical Specs, Diversity, and Connections TPS10.1L LA EN 3 Connections Side Connectors Rear Connectors TV ANTENNA CVBS R AUDIO SERV .U HDMI 2 (option) 19500_001_130408.eps 130408 Figure 2-1 Connection overview Note: The following connector colour abbreviations are used - D0+ Data channel (acc.
Page 4
Technical Specs, Diversity, and Connections EN 4 TPS10.1L LA - Shield 6 - Service / UART - D0- Data channel - Ground 10 - CLK+ Data channel - UART_TX Transmit 11 - Shield - UART_RX Receive 12 - CLK- Data channel 13 - Easylink/CEC Control channel 7- Cinch: Video YPbPr - In, Audio - In...
Spare Parts the following points: • Route the wire trees correctly and fix them with the For the latest spare part overview, consult your Philips Spare mounted cable clamps. Part web portal. • Check the insulation of the Mains/AC Power lead for external damage.
Page 6
Precautions, Notes, and Abbreviation List EN 6 TPS10.1L LA result in sets which have the same CTN (Commercial Type 6 = play 16 : 9 format, 12 = play 4 : 3 Number; e.g. 28PW9515/12) but which have a different B.O.M. format number.
Page 7
6.5 MHz. L' is Band (VESA standard for communication I, L is all bands except for Band I channel and display). Using E-DDC, LG.Philips LCD (supplier) the video source can read the EDID Loudspeaker information form the display.
Page 8
SOPS Self Oscillating Power Supply Serial Peripheral Interface bus; a 4-wire synchronous serial data link standard S/PDIF Sony Philips Digital InterFace SRAM Static RAM Service Reference Protocol Small Signal Board Spread Spectrum Clocking, used to reduce the effects of EMI...
Mechanical Instructions TPS10.1L LA EN 9 4. Mechanical Instructions Index of this chapter: Notes: 4.1 Cable Dressing • Figures below can deviate slightly from the actual situation, 4.2 Service Positions due to the different set executions. 4.3 Assembly/Panel Removal 4.4 Set Re-assembly Cable Dressing 19500_100_130411.eps 130411...
Page 10
Mechanical Instructions EN 10 TPS10.1L LA 19500_101_130411.eps 130411 Figure 4-2 Cable dressing (39" 3000 series) 19500_102_130411.eps 130411 Figure 4-3 Cable dressing (42"-46" 3000 series) back to 2013-Apr-26 div. table...
Page 11
Mechanical Instructions TPS10.1L LA EN 11 Service Positions For easy servicing of a TV set, the set should be put face down on a soft flat surface, foam buffers or other specific workshop tools. Ensure that a stable situation is created to perform measurements and alignments.
Page 12
Mechanical Instructions EN 12 TPS10.1L LA 4.3.1 Rear Cover screws [2], [3]that secure the rear cover. Refer to Figure 4-4 for details. 2. Gently lift the rear cover from the TV. Make sure that wires Refer to Figure 4-4 for details. and cables are not damaged while lifting the rear cover Warning: Disconnect the mains power cord before removing from the set.
Page 13
Mechanical Instructions TPS10.1L LA EN 13 4.3.3 Power Supply Unit (PSU) Caution: it is mandatory to remount all different screws at their original position during re-assembly. Failure to do so may result in damaging the PSU. 1. Gently unplug all connectors from the PSU. 2.
Service Modes, Error Codes, and Fault Finding EN 14 TPS10.1L LA 5. Service Modes, Error Codes, and Fault Finding Index of this chapter: Life Timer 5.1 Test Points During the life time cycle of the TV set, a timer is kept (called 5.2 Service Modes “Op.
Page 15
Service Modes, Error Codes, and Fault Finding TPS10.1L LA EN 15 – Automatic user menu time-out (menu switches controls will not have I+ button, but an “INFO” button back/OFF automatically. instead. – Auto Volume levelling (AVL). How to Exit SDM How to Activate SDM •...
Page 16
Service Modes, Error Codes, and Fault Finding EN 16 TPS10.1L LA Main Menu Sub-menu 1 Sub-menu 2 Description Download from USB Copy Channel List from USB To download several settings from the USB stick to the TV Copy NVM from USB Copy Readable Info from USB Copy EDID from USB Initialize NVM...
Page 17
Service Modes, Error Codes, and Fault Finding TPS10.1L LA EN 17 Default value Item Item value 32" 39" 42" Description W/B Pattern W/B Pattern Gain ADC Gain Offset Offset RGB ColorTemp cool The current set of color temperature Scaler MST6931XP Scaler model Gain R137...
Page 18
Service Modes, Error Codes, and Fault Finding EN 18 TPS10.1L LA • Press the MENU/HOME button on the remote control • Press the POWER button on the remote control transmitter. transmitter. • Press the POWER button on the television set. Stepwise Start-up Standby Soft Mode Command Received,...
Page 19
A description on how to upgrade the main 1. ComPair helps to quickly get an understanding on how to software can be found in the DFU or on the Philips website. repair the chassis in a short and effective way.
Service Modes, Error Codes, and Fault Finding EN 20 TPS10.1L LA • FUS_clustername_version.zip: Contains the “autorun.upg” which is needed to upgrade the TV main software and the software download application. • NVM_clustername_version.zip: Default NVM content. Must be programmed via ComPair. 5.5.7 How to Copy NVM Data to/from USB When copying data to and from a USB memory stick, the folder...
Service Modes, Error Codes, and Fault Finding TPS10.1L LA EN 21 – ERROR: 034 013 000 000 000: Error code 13 was Fault Finding and Repair Tips detected first and error code 34 is the last detected Note: (newest) error •...
Page 22
Service Modes, Error Codes, and Fault Finding EN 22 TPS10.1L LA 5.8.10 Display option code Attention: In case the SSB is replaced, always check the Panel Code in CSM, even when picture is available. Performance with the incorrect display option code can lead to unwanted side-effects for certain conditions.
Alignments(Option) TPS10.1L LA EN 23 6. Alignments(Option) Index of this chapter: In case you have a colour analyser: 6.1 General Alignment Conditions • Measure with a calibrated (phosphor- independent) color 6.2 Hardware Alignments analyser (e.g. Minolta CA-210) in the centre of the screen. 6.3 Software Alignments Consequently, the measurement needs to be done in a 6.4 Option Settings...
Alignments(Option) EN 24 TPS10.1L LA Option Settings 6.5.1 Reset of Repaired SSB 6.4.1 Introduction Instruction After NVM replacement, reload MAC address via SAM menu.This ensures the correct MAC address to be available in The microprocessor communicates with a large number of I CSM for future repair actions.
Circuit Descriptions TPS10.1L LA EN 25 7. Circuit Descriptions Introduction Index of this chapter: 7.1 Introduction The TPS10.1L LA is a new chassis launched in LATAM in 7.2 Power Supply 2013. The whole range is covered by SCALER MST6931. 7.3 DC/DC Converters The major deltas versus its predecessor support ATV, DTV;...
Page 26
Circuit Descriptions EN 26 TPS10.1L LA 7.1.3 SSB Cell Layout DC/DC TUNER MST6931XP HDMI Headphone AUDIO AMP HDMI ANALOG I/O SERVICE CONNECTOR 19500_200_130415.eps 130415 Figure 7-1 SSB layout cells (top view) back to 2013-Apr-26 div. table...
Page 27
The following displays can be distinguished: specifications! This part is available in the regular market. • CCFL/EEFL backlight: power panel is conventional IPB Consult the Philips Service web portal for the order codes of the • LED backlight: panels. - side-view LED without scanning: PSL power panel - side-view LED with scanning: PSLS power panel Important delta’s with the TPS10.L LA classis platform are:...
Page 28
Circuit Descriptions EN 28 TPS10.1L LA • +3V3-STANDBY, power supply for LED/IR receiver and Connector controls Number CN8101 CN9101 CN8101 CN9101 CN8501 CN9101 • +12V, input from the power supply for the panel Descriptio common(active mode) to panel to SSB to panel to SSB to panel...
Page 29
Circuit Descriptions TPS10.1L LA EN 29 7.4.2 Front-End DTV part • RealMedia Decoder The Front-End for DVB part consist of the following key The MST6931XP combines front-end video processing components: functions, such as NTSC/PAL/SECAM Video Decoder, MPEG-2/H.264 decode, analog video decode and HDMI reception, with advanced back-end video picture •...
IC Data Sheets EN 30 TPS10.1L LA 8. IC Data Sheets This chapter shows the internal block diagrams and pin configurations of ICs that are drawn as “black boxes” in the electrical diagrams (with the exception of “memory” and “logic” ICs).
Page 31
IC Data Sheets TPS10.1L LA EN 31 Diagram 10-4-8 MSB1400 Demod, B08, MSB1400 Demod(IC U101) Pinning Information I 2CS _SCL TS_D[6] TS_D[7] Pin 1 XTAL_OUT TS_CLK SSPI_C LK XTAL_IN SSPI_ DI AVDD33 RFAGC SSPI_ DO IFAGC RESE TZ SSPI_C SZ VDD33 19500_300_130409.eps 130409...
IC Data Sheets EN 32 TPS10.1L LA Diagram 10-4-10 Earphone pre amp, B10, APA2176A(IC U606) Block diagram APA 2 1 7 6 A ROUT LOUT PVDD Shutdown Charge Power and circuit Pump Depop circuit circuit PGND CVSS Pinning information 16 LSD 15 GND PVDD 2 14 RIN...
Page 33
KEYBOARD CONTROL (1057) CN601 CN701 HDMI 1...
Need help?
Do you have a question about the 32PFL3008D/78 and is the answer not in the manual?
Questions and answers