Page 1
Koninklijke Philips Electronics N.V. or their respective owners. TP Vision Netherlands B.V. reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. PHILIPS and the PHILIPS’ Shield Emblem are used under license from Koninklijke Philips Electronics N.V.
& Notes: drivers. • Figures can deviate due to the different set executions. Table 2-1 Described Model Numbers and Diversity Mechanics Block Diagrams Schematics 32PFL3008/98 10.1 10.3 10.4 10.5 10.6 11.1 32PFL3008/56 10.1 10.3...
Page 3
Technical Specs, Diversity, and Connections TPS10.1A LA EN 3 Connections HDMI 1 Y/VEDIO Pb AUDIO VEDIO OUT COMPONENT/VEDIO IN PC IN 19450_001_130124.eps 130124 Figure 2-1 Connection overview Note: The following connector colour abbreviations are used 4 - Head phone (Output) (acc.
Page 4
EN 4 TPS10.1A LA Technical Specs, Diversity, and Connections 17 - Ground - +5V +5 V 18 - +5V 10 - Ground Sync 19 - HPD Hot Plug Detect 11 - Ground Red 20 - Ground 12 - DDC_SDA DDC data 13 - H-sync 0 - 5 V 14 - V-sync...
Spare Parts the following points: • Route the wire trees correctly and fix them with the For the latest spare part overview, consult your Philips Spare mounted cable clamps. Part web portal. • Check the insulation of the Mains/AC Power lead for external damage.
Page 6
EN 6 TPS10.1A LA Precautions, Notes, and Abbreviation List result in sets which have the same CTN (Commercial Type 6 = play 16 : 9 format, 12 = play 4 : 3 Number; e.g. 28PW9515/12) but which have a different B.O.M. format number.
Page 7
6.5 MHz. L' is Band (VESA standard for communication I, L is all bands except for Band I channel and display). Using E-DDC, LG.Philips LCD (supplier) the video source can read the EDID Loudspeaker information form the display.
Page 8
SOPS Self Oscillating Power Supply Serial Peripheral Interface bus; a 4-wire synchronous serial data link standard S/PDIF Sony Philips Digital InterFace SRAM Static RAM Service Reference Protocol Small Signal Board Spread Spectrum Clocking, used to reduce the effects of EMI...
Mechanical Instructions TPS10.1A LA EN 9 4. Mechanical Instructions Index of this chapter: Notes: 4.1 Cable Dressing • Figures below can deviate slightly from the actual situation, 4.2 Service Positions due to the different set executions. 4.3 Assembly/Panel Removal 4.4 Set Re-assembly Cable Dressing 19450_100_130112.eps 130112...
Page 10
EN 10 TPS10.1A LA Mechanical Instructions 19450_101_130116.eps 130116 Figure 4-2 Cable dressing (3008 series 39") 19450_102_130116.eps 130116 Figure 4-3 Cable dressing (3008 series 42") back to 2013-Sep-06 div. table...
Page 11
2. Lift the rear cover from the TV. Make sure that wires and Assembly/Panel Removal cables are not damaged while lifting the rear cover from the Instructions below apply to the 32PFL3008/98, but will be set. similar for other models.
Page 12
EN 12 TPS10.1A LA Mechanical Instructions 19450_106_130112.eps 130112 Figure 4-5 Rear cover removal 4.3.3 Small Signal Board (SSB) Refer to Figure 4-6 for details. Caution: it is mandatory to remount all different screws at their original position during re-assembly. Failure to do so may result in damaging the SSB.
Page 13
Mechanical Instructions TPS10.1A LA EN 13 4.3.5 Speakers 4.3.9 LCD Panel 1. Gently release the tapes that secure the speaker cables. 1. Remove the SSB as described earlier. 2. Unplug the speaker connector from the SSB. 2. Release the clips from the LVDS connector that connects 3.
EN 14 TPS10.1A LA Service Modes and Fault Finding 5. Service Modes and Fault Finding Index of this chapter: Software Identification, Version, and Cluster 5.1 Test Points The software ID and version will be shown in the main menu 5.2 Service Modes display of CSM.
Page 15
Service Modes and Fault Finding TPS10.1A LA EN 15 Default value Item Item value 32" 39" 42" Description Gain ADC Gain Offset Offset RGB Burn in Turn on or turn off Burn in pattern EEPROM Init Initial all EEPROM except the HDCP key and product serial number Bcak LIT Time 00003.4 00000.
Page 16
A description on how to upgrade the main check that what the current TV software: software can be found in the DFU or on the Philips website. 1. Press the “456987” button on the remote control to enter the CSM mode.
Page 17
Service Modes and Fault Finding TPS10.1A LA EN 17 5.4.5 Update the TV software • FUS_clustername_version.zip: Contains the “autorun.bin” which is needed to upgrade the TV main software and the software download application. 1. Turn the TV on and wait for it to boot completely. •...
EN 18 TPS10.1A LA Alignments 6. Alignments Index of this chapter: 6.1 General Alignment Conditions 6.2 Reset of Repaired SSB 6.3 Cable position numbers General Alignment Conditions Perform all electrical adjustments under the following conditions: , 50/ 60 3 Hz. •...
7.1.2 PHILIPS 3000 series Architecture Overview For details about the chassis block diagrams refer to chapter Block Diagrams An overview of the PHILIPS AP 3000 architecture can be found in Figure 9.4. back to 2013-Sep-06 div.
Page 20
EN 20 TPS10.1A LA Circuit Descriptions 7.1.3 SSB Cell Layout xxPFL3008 MST6931 DC/DC HDMI ANALOG I/O VIDEO IN VEDIO OUT SPDIF 19450_200_130112.eps 130112 Figure 7-1 xxPFL3008 SSB layout cells (top view) back to 2013-Sep-06 div. table...
Page 21
Circuit Descriptions TPS10.1A LA EN 21 7.1.4 SSB Cell Layout 42PFL3008 MST6931 DC/DC HDMI ANALOG I/O VEDIO OUT VIDEO IN 19450_201_130116.eps 130116 Figure 7-2 42PFL3008 SSB layout cells (top view) back to 2013-Sep-06 div. table...
- direct-view LED with 2D-dimming: PSDL power board. specifications! This part is available in the regular market. Consult the Philips Service web portal for the order codes of the boards. PSL stands for Power Supply with integrated LED-drivers.
Page 23
Circuit Descriptions TPS10.1A LA EN 23 DC/DC Converters • +1V8, supply voltage for DDR2 (diagram B03B) The on-board DC/DC converters deliver the following voltages • +3V3, general supply voltage (depending on set execution): • +3.3V-TUN, supply voltage for tuner • +5V-STANDBY, permanent voltage for the Stand-by •...
Page 24
EN 24 TPS10.1A LA Circuit Descriptions MST6931 CN501 CN502 HDMI 1 HDMI 2 19450_205_130128.eps 130128 Figure 7-6 HDMI input configuration The HDMI connector has the following specifications: • +5V detection mechanism • Stable clock detection mechanism • Integrated EDID • HPD control •...
IC Data Sheets TPS10.1A LA EN 25 8. IC Data Sheets This chapter shows the internal block diagrams and pin configurations of ICs that are drawn as “black boxes” in the electrical diagrams (with the exception of “memory” and “logic” ICs).
EN 26 TPS10.1A LA IC Data Sheets Diagram 10-3-6 Earphone pre amplifier B06, APA2176A (IC U602) Block diagram APA 2 1 7 6 A ROUT LOUT PVDD Shutdown Charge Power and circuit Pump Depop circuit circuit PGND CVSS Pinning information 16 LSD 15 GND PVDD 2...
Page 27
IC Data Sheets TPS10.1A LA EN 27 Diagram 10-3-8 AUDIO Amplifier B08, APA2614RI-TRG (IC U601) Block diagram LBSP APA2 6 1 4 VCLAMP LPVDD LPVDD LOUTP FB MONO Select Gate LOUTP LOUTP FB Drive LINP PGND VCLAMP Gain PLIMIT Logic Control LPVDD LBSN...
Page 28
EN 28 TPS10.1A LA IC Data Sheets Personal Notes: 10000_012_090121 back to 2013-Sep-06 div. table...
Block Diagrams TPS10.1A LA EN 35 9. Block Diagrams Wiring diagram 32" 3008 series WIRING DIAGRAM 32" (3008 series) Board Level Repair See note in Chapter 6 about cable position numbers Component Level Repair Only for authorized workshops to panel MAIN POWER SUPPLY (1054) CN401...
Block Diagrams TPS10.1A LA EN 36 Wiring diagram 39" 3008 series WIRING DIAGRAM 39" (3008 series) Board Level Repair See note in Chapter 6 about cable position numbers Component Level Repair Only for authorized workshops to panel MAIN POWER SUPPLY (1054) CN701 CN401...
Block Diagrams TPS10.1A LA EN 37 Wiring diagram 42" 3008 series WIRING DIAGRAM 42" (3008 series) Board Level Repair See note in Chapter 6 about cable position numbers Component Level Repair Only for authorized workshops to panel CN8101 MAIN POWER SUPPLY (1054) CN701 CN401...
Page 41
Circuit Diagrams and PWB Layouts TPS10.1A LA EN 47 10.3 B 715G5740 DVB-T/C SSB (xxPFL3008) 10-3-1 Power Power Backlight Control +5V_Normal +5V_Normal 6-12 From R702 R728 Power BL_EN Board Q702 R704 BL_EN C702 R703 BL_PWM NC/10N 50V NC/10K Q707 CN701 P12V MMBT3904 R727...
Page 50
Circuit Diagrams and PWB Layouts TPS10.1A LA EN 56 10-3-10 SSB layout top 2012-10-27 SSB Layout Top 715G5740 19450_517_130111.eps 130111 back to 2013-Aug-30 div.table...
Page 51
Circuit Diagrams and PWB Layouts TPS10.1A LA EN 57 10-3-11 SSB layout bottom 2012-10-27 SSB Layout Buttom 715G5740 19450_518_130111.eps 130111 back to 2013-Aug-30 div.table...
Need help?
Do you have a question about the 32PFL3008/98 and is the answer not in the manual?
Questions and answers